Fujitsu ScanPartner 15C Procedimentos de instalação - Página 2
Procurar online ou descarregar pdf Procedimentos de instalação para Scanner Fujitsu ScanPartner 15C. Fujitsu ScanPartner 15C 5 páginas. Image scanner
Também para Fujitsu ScanPartner 15C: Manual do utilizador (23 páginas), Especificações (2 páginas), Upgrade Manual (6 páginas), Manual do utilizador (26 páginas), Instruções de substituição e limpeza de consumíveis (7 páginas)
![Fujitsu ScanPartner 15C Procedimentos de instalação](/uploads/products/server2/2440345/2440345.png)
ScanPartner15C\600C\620C\93GX\3091DC\3092DC
Next connect the power cord to the scanner and a wall outlet, and then turn on the scanner.
The power, ready and paper jam LED will all light up, afterwards the scanner will complete its
self initialization and the paper jam light will go off in approximately 10 seconds. The SP93GX
power LED will flash and then go solid. The SP3091\3092DC's will flash a P, 0, and then 1.
Once this step is completed turn off the scanner and install the SCSI host adapter.
Step B: Installing the AVA2902E SCSI Host Adapter
1. Shut down your PC and remove the case cover.
2. Locate a free PCI slot and remove the back plate if necessary.
3. Install the SCSI controller in an open PCI slot.
Make sure that the card is seated completely in the slot and secured in the frame.
Warning! Failure to secure the SCSI controller in the PC can result in damage to the
SCSI card, scanner, and/or your system.
4. Next boot your PC without the scanner attached and go to device manager. The
SCSI controller will be listed as "aic78xx" and should be at IRQ 15 or lower and not
sharing its IRQ with any other device in the system.
Step C: Installing the SCSI drivers
1. When the New Hardware wizard comes up allow Windows to finish installing the files
for the SCSI controller.
2. Then go to www.adaptec.com, and click on the "search" tab. Scroll down to the
"Enter key word or quoted phrase" box and type in "aspi32.exe."
3. Next scroll down to the drivers section, click on "aspi32.exe" and follow the prompts
to download it to your desktop or a new folder.
4. Afterwards go to that location and double click on the "aspi32.exe" icon.
5. Follow the prompts.
6. Reboot and check for errors. If no errors shut down your system and go to the next
step.
Step D: Connecting the Scanner.
Warning ensure that the power is off when connecting or disconnecting any cables to the
scanner or workstation.
Setting the SCSI ID: The factory setting for the Scanner is 6, however, selecting a
different SCSI ID may be required when there are several devices on a SCSI chain.
Using a suitable tool, turn the selector switch until the arrow points to the desired ID
number (see figure 2-3). Setting the ScanPartner SCSI ID to 0, 1, or 7 is NOT
recommended as these settings are typically reserved for hard drives and the SCSI host
adapter.
Setting Termination: The Fujitsu ScanPartner comes complete with a built in SCSI
terminator (see Fig 2-3). If the Scanner is the last device in the SCSI chain, the
terminator should be switched to 'On'. If the Scanner is not the last device, the
terminator should be off.
Win95\98\ME Installation Procedure
Rev050404A