Fujitsu Eternus DX200F Manual de operação - Página 16

Procurar online ou descarregar pdf Manual de operação para Armazenamento Fujitsu Eternus DX200F. Fujitsu Eternus DX200F 48 páginas. Hybrid storage systems, all-flash arrays, power synchronized unit
Também para Fujitsu Eternus DX200F: Manual de configuração (10 páginas), Manual de configuração (28 páginas), Manual de configuração (13 páginas), Manual de configuração (16 páginas), Manual de configuração (38 páginas), Precauções de segurança (12 páginas)

Imprimir página
Fujitsu Eternus DX200F Manual de operação
Chapter 1
Component Name/LED Name
1.4
Components (Rear)
4.
Host interface (CA#0)
Install host interfaces. For details, refer to
5.
Host interface (CA#1)
Install host interfaces. For details, refer to
6.
IDENTIFY/SCU READY LED
7.
CA#0 FAULT LED
8.
READY/FAULT LED
9.
CA#1 FAULT LED
10. MASTER LED
11. LINK/FAULT LED
12. LAN ACCESS LED
13. LAN LINK LED
The states of LEDs are listed below.

Table 1.3 Status and Meanings of Each LED (Controller)

LED name
IDENTIFY/SCU READY
READY/FAULT
MASTER
CA FAULT
LINK/FAULT
LAN ACCESS
LAN LINK
"■ Host Interfaces" (page
"■ Host Interfaces" (page
LED status
(blinks green)
(green)
(blinks green)
(amber)
(blinks amber)
(green)
(amber)
(green)
(amber)
(blinks green)
(green)
16
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
17).
17).
Meaning
•
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installa-
tion location of the controller is identified.
System Capacitor Unit (SCU) is charging.
•
The controller is in normal status.
An error has occurred during startup.
The controller is performing the initial setup after the power is
•
turned on.
The controller is in error status.
•
The controller is set as a Master CM.
The host interface is in error status.
The link between the host interface port and the destination port
has been established.
The host interface port is in error status.
Data is being sent or received via the LAN port (for operation
management).
The link between the LAN port (for operation management) and
the destination has been established.
P3AM-8472-01ENZ0