AEG 210621236-11052010 Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Frigorífico AEG 210621236-11052010. AEG 210621236-11052010 24 páginas. Electrolux fridge-freezer user manual

Imprimir página
14
What to do if...
Problem
Water flows on the
ground.
There is too much frost
and ice.
The temperature in the
appliance is too high.
The temperature in the
refrigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp comes on.
Possible cause
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Products are not wrapped prop-
erly.
The door is not closed correctly. Refer to "Closing the door".
The Temperature regulator may
be set incorrectly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Products are too near to each
other.
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket correct-
ly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
Solution
Attach the melting water outlet
to the evaporative tray.
Wrap the products better.
Set a higher temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
1
2