AEG ABE818F6NS Manual do utilizador - Página 16

Procurar online ou descarregar pdf Manual do utilizador para Frigorífico AEG ABE818F6NS. AEG ABE818F6NS 36 páginas.
Também para AEG ABE818F6NS: Instruções de instalação (12 páginas)

16
www.aeg.com
Problem
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
DEMO appears on the dis‐
play.
A
or
shown instead of numbers
on the temperature display.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Closing the door
1. Clean the door gaskets.
Possible cause
The Frostmatic function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The Frostmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the dem‐
onstration mode.
Temperature sensor prob‐
or
symbol is
lem.
Solution
Switch off Frostmatic func‐
tion manually, or wait until
the function deactivates au‐
tomatically to set the temper‐
ature. Refer to "Frostmatic
function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "Frostmatic func‐
tion" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
tips" chapter.
To exit the demonstration
mode, press and hold the
OK button for approximately
10 seconds until you hear a
long sound and the display
turns off for a short time.
Contact the nearest Author‐
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.