AEG ARCTIS Manual de Instruções - Página 10

7. Remove the plugs (G) and fit them on

the opposite side.

8. Insert the pin of the door bearing (1)

into the left hand cavity and screw

the bearing firmly into place with the

screws (K).

9. Move the separate part (L) of the ven-

tilation grille from the left to the right

and fit it on the opposite side.

10. Unscrew the handle and refit it on the

opposite side.

plastic plugs removed.

Pannelling the door

1. Take off the door frame section opposite to

the door handle.

2. Loosen, without removing them, all remaining

screws securing the door frame.

3. Slide in the decor panel from the frameless

side, then fasten again the frame to the door

including the previously removed frame sec-

tion.

Note:

The overall dimensions of the decor panel must be 1 to 2 mm less than

those of the door, with a maximum thickness of 4 mm.

The holes that are not used are to be masked with the

Installation