AEG OKO-SANTO 1454-6 iU Instruções de utilização e de instalação - Página 24
Procurar online ou descarregar pdf Instruções de utilização e de instalação para Frigorífico AEG OKO-SANTO 1454-6 iU. AEG OKO-SANTO 1454-6 iU 28 páginas. Built-in refrigerator
Imprimir página
Symptom
Appliance does not work.
The compressor runs con-
tinuously.
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the door
seal.
The compressor does not
start immediately after
changing the temperature
setting.
Water in the bottom of the
cabinet.
24
Possible Cause
Appliance is not switched
on.
Mains plug is not plugged
in or is loose.
Fuse has blown or is
defective
Socket is defective.
Temperature is set too
cold.
Temperature is not
properly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Light bulb is defective.
Door seal is not airtight
(possibly after reversing
the door).
This normal, no error has
occurred.
Water drain hole is
blocked.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if nec-
essary.
Mains malfunctions are to
be corrected by an
electrician.
Turn the thermostat knob
to a warmer setting tem-
porarily.
Please look in the "Initial
Start Up" section.
Do not leave the door open
any longer than necessary.
Turn the thermostat knob
to a colder setting tem-
porarily.
Please look in the
"Installation location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.