2.3 Installing the Scanner
Application
For scanning documents with this scanner, both scanner
driver and image capturing application software (called
"application" hereafter) must be installed on your PC.
The following scanner drivers and applications are pro-
vided:
• Scanner Driver:
FUJITSU TWAIN 32 Scanner Driver
FUJITSU ISIS Scanner Driver
• Scanning application:
ScandAll 21 (for FUJITSU TWAIN 32)
TM
QuickScan Pro
Install the appropiate scanner driver for the application
you will use. The following sections descri be installa-
tion of each driver and application.
For FUJITSU TWAIN32 Scanner Driver
■ Preparation
Confirm the following items before installing the appli-
cation.
• Take out the Setup CD-ROM from its pack-
age, but do not insert the Setup CD-ROM
into the CD driver yet.
• Connect the scanner correctly to your PC.
For details on how to connect the scanner,
HINT
refer to "2.2 Connecting the Scanner to
Your PC" on page 3.
• Uninstall any older versions of FUJITSU
TWAIN 32 driver if it has already been
installed.
Uninstall [Scanner Utility for Microsoft Win-
ATTENTION
dows] from [Add/Remove Programs] on
the control panel.
• There are two types of FUJITSU TWAIN 32:
One of the following driver software will be
automatically installed according to your Oper-
ating System (OS).
For Windows 98, Windows Me, Windows
2000, and Windows XP:
FUJITSU TWAIN32 V9
For Windows 95, Windows NT 4.0:
(for FUJITSU ISIS)
fi-5530C Image Scanner Getting Started
FUJITSU TWAIN32 V8
• When using Windows 95 or Windows NT
4.0:
ASPI Manager V4.01 or later is required (gener-
ally comes with SCSI board products).
■ Installing the FUJITSU TWAIN32
Scanner Driver
Windows XP screenshots are used in this
HINT
section. The windows and operations may
slightly vary depending on your OS.
1. Press the power button to turn ON the scanner.
2. Turn on your PC and log on to Windows.
When using Windows NT 4.0, Windows
ATTENTION
2000 or Windows XP, log on as a user with
"Administrator" privileges.
3. If the scanner is automatically detected,
[Found New Hardware Wizard] or [Add/
Remove Hardware Wizard] dialog box will
appear. Click [Cancel] to close the Wizard win-
dow.
4. Insert the Setup CD-ROM into the CD drive.
⇒
<SETUP DISK START UP SCREEN>
appears.
This screen may not appear when the
ATTENTION
"Autoplay" setting of your CD drive is off.
In this case, run "Install.exe" in this CD-
ROM directly from "Explorer" or "My Com-
puter".
5
Imprimir página