Brother Quattro 6000D Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Software Brother Quattro 6000D. Brother Quattro 6000D 48 páginas. Kit de actualización iii
Também para Brother Quattro 6000D: Manual (42 páginas), Manual de operação (50 páginas), Manual de operação (6 páginas), Manual de operação (29 páginas), Manual de operação (21 páginas), (Inglês) Manual de instruções (49 páginas), (Inglês) Manual de instruções (21 páginas), (Inglês) Manual de instruções (48 páginas)

Imprimir página
Brother Quattro 6000D Manual do utilizador
e
Place the embroidery sheet in the upper
frame, align the guide line on the embroidery
sheet with the center mark (line) on the
fabric, and then press down on the left and
right locking levers until they click into place.
a
Locking levers
Memo
• The fabric can also be positioned in the border
embroidery frame by aligning the edge of the fabric
with the inner markings on the upper frame.
Note
• If there is excess fabric after the center of the
embroidering area is aligned with the center of the
border embroidery frame, fold over the excess
fabric, place it on top of the upper frame, and then
press down on the levers. Be careful that the folded
excess fabric is not caught in the embroidering area.
f
Remove the embroidery sheet, and then
gently pull the four sides of the fabric to
remove any excess slack. Be careful so that
fabric is not stretched out of shape. Finally,
check that the fabric is firmly within the
hoop.
Attaching the Border Embroidery
Frame to the Embroidery Unit
CAUTION
• After firmly hooping the fabric in the border
embroidery frame, attach the frame to the
embroidery unit. Otherwise, the needle may break
and cause injuries.
• Before attaching the border embroidery frame to
the embroidery unit, make sure that the needle and
presser foot have been raised. Otherwise, the
needle may break and cause injuries.
Note
• Before attaching the border embroidery frame, wind
the bobbin with thread and install it.
a
Make sure that the needle and presser foot
have been raised. If the needle has not been
raised, press the "Needle Position" button to
raise it. If the presser foot has not been raised,
press the "Presser Foot Lifter" button to raise
it.
b
Make sure that the embroidery unit carriage
has moved to its initial position.
c
Align the guide on the border embroidery
frame with the right edge of the embroidery
frame holder.
b
a
Embroidery frame holder
b
Guide on border embroidery frame
a
7