Brother MFC-J245 Manual do utilizador - Página 29

Procurar online ou descarregar pdf Manual do utilizador para Scanner Brother MFC-J245. Brother MFC-J245 48 páginas.
Também para Brother MFC-J245: Manual de configuração rápida (20 páginas), Manual do utilizador (44 páginas), Manual de configuração rápida (21 páginas), Manual do utilizador (47 páginas)

Mac OS

X Operation

CALIBRATION

Calibration is critical because it allows the image quality to be "balanced" for your computer and scanner

combination. If you switch the computer that you use with your scanner or change scanners, you must

calibrate again.

Note that you must be logged in as an Administrator to calibrate the system. See SETTING

ADMINISTRATOR PRIVILEGES uu on page 17 for further information.

This calibration process uses the special black and white calibration sheet (see picture on page iv) that was

included with your scanner. When calibrating, make sure the side with the black bar is facing down and note

the direction of the arrows for proper insertion.

If you lose the black and white calibration paper that was included with your scanner, you can use any plain

"White" (the brighter the "White" the better) piece of A4 size printer paper to perform the calibration. Simply

fold the paper in half and insert the end opposite the fold into the scanner first when calibrating.

The following message will be displayed (see below).

Note

When the image quality has become unsatisfactory, we recommend you clean the scanner with the

included cleaning sheet (see Tips & Cautions page) and then recalibrate the scanner.

Calibration is a critical step in setting up your scanner. It allows the scanned colour data to be "calibrated" to

your computer and scanner combination for best image quality. If at any time you switch the computer that

you use with your scanner or change scanners, you will need to re-calibrate.

The following steps guide you through calibration of your DSmobile 700D scanner using the built-in

"Image Capture" software on your Mac OS

a calibration is performed, it does not need to be re-done if you use to another application on the same

computer.

X along with the Brother driver and GUI. Note that once