Fujitsu F2MC-8FX Series Manual de configuração - Página 18

Procurar online ou descarregar pdf Manual de configuração para Placa-mãe Fujitsu F2MC-8FX Series. Fujitsu F2MC-8FX Series 23 páginas. 8-bit microcontroller
Também para Fujitsu F2MC-8FX Series: Manual de operação (20 páginas), Nota de aplicação (12 páginas), Nota de aplicação (23 páginas), Manual de configuração (18 páginas), Manual de configuração (19 páginas), Manual de configuração (30 páginas), Nota de aplicação (20 páginas), Nota de aplicação (21 páginas), Manual de operação (21 páginas), Manual do utilizador (24 páginas), Manual de configuração (17 páginas)

3 EV Board Operation

Before power on, connect the motor lines to the motor connector and the hall sensor

connector according to the following direction. Refer to Figure 3.1.

Note: If the driving method is Back EMF, the hall sensor connector should not be connected.

If you want to select the hall sensor, the switchers are set as J1(2-3),J2(2-3), and J3(2-3).

Otherwise, the switchers are set as J1(1-3),J2(1-3), and J3(1-3). Switch on the power and

the power LED turns

on.

you want to change the FW driving method, press the hall sensor/B-EMF key when the

motor is stopped. Then, the LED3 turns off. It means the FW driving method is hall sensor.

Refer to Figure 3.2.

Notes: The selection of the FW driving method should match with the selection of switchers.

EV Board MB2146-440-E Setup Guide

Chapter 3 EV Board Operation

Figure 3.1

When the LED3 is on, it means the FW driving method is B-EMF. If

Page 16

Motor connector

GND

Hall sensor connector