Fujitsu MB2146-401 Nota de aplicação - Página 13
Procurar online ou descarregar pdf Nota de aplicação para Placa-mãe Fujitsu MB2146-401. Fujitsu MB2146-401 23 páginas. F2mc-8fx family evaluation board
Também para Fujitsu MB2146-401: Manual de configuração (30 páginas), Manual de operação (34 páginas)
Imprimir página
3.4 Evaluation board
3.4.1 Jumper settings on Evaluation board
Please set jumper plugs on Evaluation board according to following:
1. Set jumper plugs JP3 and JP4 to the right supply voltage,
depending on your evaluation MCU and MCU board
(1-2: 5V, 2-3: 3.3V)
2. Set analogue power supply jumper plug JP5
(AVCC pin is connected to VCC of evaluation board)
3. Set analogue reference input jumper plug JP6
(AVR pin is connected to VCC of evaluation board)
4. Set analogue power supply (GND) jumper plug JP7
(AVSS pin is connected to VSS of evaluation board)
5. Set operation mode jumper plug JP8
(MOD pin connected to GND -> run mode)
6. Set LED jumper plugs JP1 and JP2 to connect I/O port to LEDs on evaluation
board
6
© Fujitsu Microelectronics Europe GmbH
MB2146-09 – Installation Guide
Chapter 3 Setting up the Emulation System
4
Figure 9: jumper settings on evaluation board
3
- 13 -
2
1
5
Supply only
5V DC!
MCU-AN-395002-E-V10