Indesit CA 55 NF Manual de Instruções - Página 3

Procurar online ou descarregar pdf Manual de Instruções para Frigorífico Indesit CA 55 NF. Indesit CA 55 NF 12 páginas. Refrigerator/freezer combination
Também para Indesit CA 55 NF: Manual de instruções (12 páginas)

Imprimir página

Your appliance is supplied with a 13amp fused plug

that can be plugged into a 13amp socket for

immediate use. Before using the appliance please

read the instructions below.

WARNING:

THIS APPLIANCE MUST BE EARTHED.

Replacing fuse covers:

When replacing a faulty fuse, a 13amp ASTA

approved fuse to BS 1362 should always be used and

the fuse cover re-fitted.

If the fuse cover is lost, the plug must not be used

until a replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the

correct colour as indicated by the coloured marking or

the colour that is embossed in words on the base of

the plug.

Changing the plug:

Removing the plug

If your appliance has a non-rewireable moulded plug

and you should wish to remove it to add a longer

cable or to re-route the mains cable through partitions,

units etc. please ensure that either:

The plug is replaced by a fused 13amp re-

wireable plug bearing the BSI mark of

approval.

The mains cable is wired directly into a

13amp cable outlet, controlled by a

switch (in compliance with BS 5733)

which is accessible without moving the

appliance.

Disposing of the plug

Cut off and dispose of the supplied plug if it does not

fit your socket. The cable should be cut as close as

possible to the moulded plug.

Remove the fuse.

WARNING:

To avoid a shock hazard do not insert the

discarded plug into a socket anywhere else.

Fitting a new plug

IMPORTANT:

WIRES IN THE MAINS LEAD ARE COLOURED IN

ACCORDANCE WITH THE FOLLOWING CODE...

Green and Yellow

Blue

Brown

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

Connect Green and Yellow wire to terminal marked

'E' or

or coloured Green and Yellow.

Connect Brown wire to terminal marked 'L' or

coloured red or brown.

Connect Blue wire to terminal marked 'N' or

coloured Black or Blue.

If a 13amp plug (BS 1363) is used it must be

fitted with a 13amp fuse. A 15amp plug must be

protected by a 15amp fuse, either in the plug or adaptor

or at the distribution board.

If you are in any doubt about the electrical

supply to your machine, consult a qualified

electrician before use.

CE Marking certifies that this appliance conforms to

the following EEC directives :

Low Voltage Equipment - 73/23/EEC & 93/68 EEC

Electromagnetic Compatibility 89/336/EEC, 92/31/EEC

& 93/68/EEC

- Earth

- Neutral

- Live