Indesit XH8 Series Manual de Instruções - Página 5
Procurar online ou descarregar pdf Manual de Instruções para Frigorífico Indesit XH8 Series. Indesit XH8 Series 8 páginas.
![Indesit XH8 Series Manual de Instruções](/uploads/products/server2/2492970/2492970.png)
Installation
! Before placing your new appliance into operation please read
these operating instructions carefully. They contain important
information for safe use, for installation and for care of the
appliance.
! Please keep these operating instructions for future reference.
Pass them on to possible new owners of the appliance.
Positioning and connection
Positioning
1. Place the appliance in a well-ventilated humidity-free room.
2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation to
operate correctly and save energy.
3. Leave a space of at least 10 cm between the top part of
the appliance and any furniture above it, and at least 5 cm
between the sides and any furniture/side walls.
4. Place the device far from heat sources (direct sun light,
electric kitchen etc.)
50
mm
Levelling
1. Install the appliance on a level and rigid floor.
2. If the floor is not perfectly horizontal, adjust the refrigerator
by tightening or loosening the front feet.
Electrical connections
After the appliance has been transported, carefully place it
vertically and wait at least 3 hours before connecting it to the
electricity mains. Before inserting the plug into the electrical
socket ensure the following:
• The appliance is earthed and the plug is compliant with the
law.
• The socket can withstand the maximum power of the
appliance,
• The voltage must be in the range between the values indicated
on the data plate located on the bottom left side (e.g. 220-
240V).
• The socket is compatible with the plug of the appliance. If
the socket is incompatible with the plug, ask an authorised
technician to replace it (see Assistance). Do not use extension
cords or multiple sockets.
! Once the appliance has been installed, the power supply cable
and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
! The manufacturer declines any liability should these safety
measures not be observed.
*
Varies by number and/or position, available only on certain
models.
Start-up and use
Starting the appliance
! Before starting the appliance, follow the installation
instructions (see Installation).
! Before connecting the appliance, clean the compartments and
accessories well with lukewarm water and bicarbonate.
! Electronic versions are provided with a motor protection switch
that powers on the compressor only almost 8 minutes after the
starting. The compressor also starts each time the power supply
is cut off whether voluntarily or involuntarily (blackout).
1. Connect the plug and check that the FRIDGE TEMPERATURE
indicator turns on. If the indicator stays off, please press the
ON/OFF button.
2. Set the FRIDGE TEMPERATURE on an average value. After
a few hours it will be possible to insert food in the fridge.
Cooling system
No Frost
The No Frost system circulates cold air continuously to collect
humidity and prevent ice and frost formation. The system
maintains an optimal humidity level in the compartment,
preserving the original quality of the food, preventing the food
from sticking together and making defrosting a thing of the past.
Do not block the aeration cells by placing food or containers in
direct contact with the refrigerating back panel. Close bottles
and wrap food tightly.
Using the refrigerator to its full potential
• Place only cold or lukewarm foods in the compartment•
Remember that cooked foods do not last longer than raw
foods.
• Do not store liquids in open containers: they will increase the
level of humidity in the refrigerator and cause condensation to
form.
COMPARTMENT 3 IN 1 ZONE*
This is the new box which offers maximum flexibility in order to
stock your food in an excellent way.
-store meat, fish and delicate food;
-rapid cooling of hot food from 70°C to 3°C and of other fresh
foods and leftovers
-low temperature defrosting (it inhibits the proliferation of
microorganisms).
You can get the 0°C temperature, in standard conditions, when
the fridge compartment temperature is at about 4°C.
By decreasing the fridge temperature you decrease the CHILLER
compartment temperature too.
GB
5