Indesit I6T52/AUS Manual de Instruções - Página 8

Procurar online ou descarregar pdf Manual de Instruções para Forno Indesit I6T52/AUS. Indesit I6T52/AUS 20 páginas.

Imprimir página

1. Control Panel

Replacing the Triple ring burner nozzles

Remove the pan supports and lift the burners out

of their housing. The burner consists of two separate parts

(see pictures).

Unscrew the nozzles using a 7 mm socket span-

ner. Replace the nozzles with models that are configured

for use with the new type of gas (see Table 1). The two

nozzles have the same hole diameter.

Replace all the components by completing the

above operations in reverse order.

•

Adjusting the burners' primary air :

Does not require adjusting.

•

Setting the burners to minimum:

Turn the tap to the low flame position.

Remove the knob and adjust the adjustment

screw, which is positioned in or next to the tap pin, until the

flame is small but steady.

Having adjusted the flame to the required low set-

ting, while the burner is alight, quickly change the position

of the knob from minimum to maximum and vice versa

several times, checking that the flame does not go out

Some appliances have a safety device (thermoco-

uple) fitted. If the device fails to work when the burners are

set to the low flame setting, increase this low flame setting

using the adjusting screw.

Once the adjustment has been made, replace the

seals on the by-passes using sealing wax

! If the appliance is connected to liquid gas, the regulation

screw must be fastened as tightly as possible.

! Once this procedure is finished, replace the old rating

sticker with one indicating the new type of gas used. Stic-

kers are available from any of our Service Centres.

! Should the gas pressure used be different (or vary sligh-

tly) from the recommended pressure, a suitable pressure

regulator must be fitted to the inlet pipe (in order to comply

with current national regulations).

Anti-tilt Wall Bracket

! In order to prevent accidental

tipping of the appliance, for

example by a child climbing onto

the oven door, the supplied "anti-

tilt bracket" MUST be installed!

To install the Anti-Tilt Wall Bracket:

1. Fit the cooker between the cabinets and adjust the

height of the appliance (if necessary) by means of

adjustable feet.

2. Take out the lower compartment.

3. On the wall behind the cooker draw a line along

the horizontal edge A and then along the vertical edge

B so that the lines cross (see figures below).

4. Pull the cooker out of the space between cabinets

and attach the Anti-tilt Bracket with (its shorter arm

to the wall) in the position shown in the picture below:

37 mm left and 5 mm up from the crossing of the lines

A and B, inserting two bolts of 6mm diameter in the

holes: x and y.

5. Place the cooker back between the cabinets so that

the Anti-Tilt Wall Bracket fits inside the appliance.

6. Reinsert the lower compartment.

! The Anti-Tilt Wall Bracket may be installed both on the

left and on the right handside of the cooker.