Indesit IT50L Manual de Instruções - Página 6

Procurar online ou descarregar pdf Manual de Instruções para Fogões Indesit IT50L. Indesit IT50L 24 páginas. Indesit it50g s; it50g1 s; it50l s; it50g1; it50l; it50g; itl50g1; itl50gm; itl50ga; itl50gw 50cm free standing gas cooker
Também para Indesit IT50L: Manual de Instruções (24 páginas)

Indesit IT50L Manual de Instruções
• Pry the fixing tab "V" and remove the oven burner
GB
• Unscrew the oven burner nozzle using the socket
spanner for the nozzles "Z"
spanner, and replace it with a nozzle suited to the
new type of gas (see Table 1).
Take particular care handling the spark
Take particular care handling the spark
Take particular care handling the spark
Take particular care handling the spark
Take particular care handling the spark
plug wires and the thermocouple pipes.
plug wires and the thermocouple pipes.
plug wires and the thermocouple pipes.
plug wires and the thermocouple pipes.
plug wires and the thermocouple pipes.
• Replace all the parts, following the steps
described above in the reverse order.
b )Minimum regulation of the gas oven burner with
b )
b )
b )
b )
thermostat:
• light the burner as described in the paragraph
"the oven knob" of the instruction booklet.
• turn the knob to Max
then turn the knob to the Min
• remove the knob;
• regulate the screw positioned outside the
thermostat pin until the flame is small but steady.
! in the case of liquid gas, the regulation screw
must be screwed in to the bottom.
• check that the burner does not turn off when you
turn the knob from Max
turn the knob from Max
turn the knob from Max to Min
turn the knob from Max
turn the knob from Max
you open and close the oven door quickly.
Adapting the gas grill to different types of gas
Replacing the nozzle of the grill burner:
• remove the screw and then slide out the grill
burner "V V V V V " (see Figure);
• unscrew the grill burner nozzle using the special
socket spanner for the nozzles (see Figure) or
better still a 7mm socket spanner; replace the
nozzle with a nozzle for the new type of gas (see
table 1).
V
6
"Z"
"Z", or a 7 mm socket
"Z"
"Z"
Max
Max
Max for about 10 minutes and
Max
Min
Min
Min setting;
Min
when you
when you
when you
when you
to Min and and when
to Min
to Min
to Min
I
Important
Important
Important
Important
Important
On completion of the operation, replace the old
rating sticker with one indicating the new type of gas
used. This sticker is available from our Service
Centres.
Note
Note
Note
Note
Note
Should the pressure of the gas used be different (or
vary) from the recommended pressure, it is
necessary to fit a suitable pressure regulator onto
the inlet pipe in compliance with current National
Regulations relative to "regulators for channelled
gas".