Indesit MVK6 G1 RF Manual de Instruções - Página 17

Procurar online ou descarregar pdf Manual de Instruções para Fogões Indesit MVK6 G1 RF. Indesit MVK6 G1 RF 28 páginas.

Imprimir página

• Is easy to inspect along its whole length so that

its condition may be checked.

• Is shorter than 1500 mm.

• Fits firmly into place at both ends, where it will be

fixed using clamps that comply with current

regulations.

! If one or more of these conditions is not fulfilled or if

the cooker must be installed according to the conditions

listed for class 2 - subclass 1 appliances (installed

between two cupboards), the flexible steel hose must

be used instead ( see below ).

Connecting a flexible jointless stainless steel

pipe to a threaded attachment

Make sure that the hose and gaskets comply with

current national legislation.

To begin using the hose, remove the hose holder on

the appliance (the gas supply inlet on the appliance

is a cylindrical threaded 1/2 gas male attachment).

! Perform the connection in such a way that the hose

length does not exceed a maximum of 2 metres,

making sure that the hose is not compressed and

does not come into contact with moving parts.

Checking the tightness of the connection

When the installation process is complete, check the

hose fittings for leaks using a soapy solution. Never

use a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas

other than the default type (this is indicated on the

rating label on the cover).

Adapting the hob

Replacing the nozzles for the hob burners:

1. Remove the hob grids and

slide the burners off their

seats.

2. Unscrew the nozzles using

a 7 mm socket spanner ( see

figure ), and replace them with

nozzles suited to the new type

of gas ( see Burner and nozzle

specifications table ).

3. Replace all the components by following the

above instructions in reverse.

Adjusting the hob burners' minimum setting:

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory

screw, which is positioned inside or next to the tap

pin, until the flame is small but steady.

! If the appliance is connected to a liquid gas

supply, the regulatory screw must be fastened as

tightly as possible.

3. While the burner is alight, quickly change the position

of the knob from minimum to maximum and vice versa

several times, checking that the flame is not

extinguished.

! The hob burners do not require primary air adjustment.

Adapting the oven

Replacing the oven burner nozzle:

1. Open the oven door fully

2. Pull out the sliding oven

bottom ( see diagram ).

3. Remove the oven burner

after unscrewing the screws V

( see figure ).

4. Unscrew the nozzle using a

special nozzle socket spanner

( see figure ) or with a 7 mm

socket spanner, and replace it

with a new nozzle that is

suited to the new type of gas

( see Burner and nozzle

specifications table ).

Adjusting the gas oven burner's minimum

setting:

1. Light the burner ( see Start-up and Use ).

2. Turn the knob to the minimum position (MIN) after

it has been in the maximum position (MAX) for

approximately 10 minutes.

3. Remove the knob.

4. Tighten or loosen the adjustment screws on the

outside of the thermostat pin ( see figure ) until the

flame is small but steady.

! In the case of natural gas, the adjustment screw must

be unscrewed by turning it anti-clockwise.