Indesit IWDC 7125 Manual de instruções de utilização - Página 3

Procurar online ou descarregar pdf Manual de instruções de utilização para Máquina de lavar/secar roupa Indesit IWDC 7125. Indesit IWDC 7125 12 páginas.
Também para Indesit IWDC 7125: Manual de instruções de utilização (12 páginas), Manual de instruções de utilização (24 páginas), Manual de instruções de utilização (24 páginas)

Imprimir página

Indesit IWDC 7125 Manual de instruções de utilização

Connecting the drain hose

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose and

must not exceed 150 cm in length.

Electrical connection

Before inserting the plug into the electrical so-

cket, make sure that:

• the socket is earthed and complies with cur-

rent regulations;

• the socket can withstand the maximum load of

the appliance, which is indicated in the Techni-

cal data table (see opposite);

• the power supply voltage falls within the values in-

dicated in the Technical data table (see opposite);

• the socket is compatible with the plug of the ap-

pliance. If this is not the case, either the socket

or the plug must be replaced.

! The machine must not be installed outdoors,

even in covered areas. It is extremely dangerous

to leave the appliance exposed to rain, storms

and other weather conditions.

! Once the machine has been installed, the

electricity socket should be easily accessible.

! Avoid using any extension cord or multiple

socket outlet.

! CAUTION: if this appliance is supplied from a

cord extension set or electrical portable outlet

device, the cord extension set or electrical por-

table outlet device must be positioned so that it

is not subject to splashing or ingress of moisture.

Connect the drain

hose, without bending

it, to a drainage duct or

a wall drain located at a

height between 65 and

100 cm from the floor;

alternatively, rest it on

the side of a washba-

sin or bathtub, faste-

ning the duct supplied

to the tap (see figure).

The free end of the

hose should not be

underwater.

! The cable should not be bent or compressed.

! The cable should be replaced only by authori-

sed technicians.

! If the supply cord is damaged, it must be repla-

ced by the manufacturer, its service agent or simi-

larly qualified persons in order to avoid a hazard.

Warning! The company shall not be held re-

sponsible for any incidents that occur if these

regulations are not observed.

The first wash cycle

Once the appliance has been installed, and before

you use it for the first time, run a wash cycle with

detergent and no laundry, using the wash cycle 2.

Technical data

Model

IWDC 7125

width 59.5 cm

Dimensions

height 85 cm

depth 53,5 cm

from 1 to 7,5 kg for the

wash programme;

Capacity

from 1 to 4,5 kg for the

drying programme

Electrical

please refer to the technical

connections

data plate fixed to the machine

maximum pressure 1 MPa

(10 bar)

Water con-

minimum pressure 0.05

nections

MPa (0.5 bar)

drum capacity 52 litres

Spin speed

up to 1200 rotations per minute

Wash: programme 2; tem-

perature 60°C at 1200 rpm;

Energy rated

run with a load of 7,5 kg.

programmes

Drying: the smaller load

according to:

(2kg) must be dried by

- AS/NZS

selecting the "

2040.2 (wa-

level. The load must consist

shing)

of 2 sheets, 1 pillowca-

- AS/NZS

se and 1 hand towel; the

2442.2 (drying)

remainder of the load must

be dried by selecting the "

" dryness level.

This appliance conforms to

the following EC Directives:

- 89/336/EEC dated

03/05/89 (Electromagnetic

Compatibility) and subse-

quent modifications

- 2012/19/EU (WEEE)

- 2006/95/EC Low Voltage)

" dryness