Indesit XWDE 961480X WSSS EU Manual rápido - Página 2
Procurar online ou descarregar pdf Manual rápido para Secador Indesit XWDE 961480X WSSS EU. Indesit XWDE 961480X WSSS EU 33 páginas.
Imprimir página
WASH CYCLES
Follow the instructions on the symbols of the garment's wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Sport: a cycle designed for washing lightly soiled sports clothing
(tracksuits, shorts, etc.); for best results, we recommend not exceeding the
maximum load indicated in the "Wash Cycle Table". We recommend using liquid
detergent and adding the amount suitable for a half-load.
Dark: use programme 2 to wash dark-coloured garments. This
programme is designed to maintain dark colours over time. We
recommend using a liquid detergent for the best results when washing
dark-coloured garments.
When you select the drying function, at the end of the washing cycle the
machine will automatically perform a delicate drying cycle that preserves the
colours of the garments. The display will show the level "
Anti-odour: use programme 3 for washing garments with bad odours
(e.g. smoke, sweat, fried food). The programme is designed to remove bad
odours while preserving the fabric fibres. Synthetics fabrics or mixed
loads should be washed at 40°, and resistant cotton fabrics at 60°.
Delicate: use programme 4 to wash very delicate garments. It is
advisable to turn the garments inside out before washing them. For best
results, use liquid detergent on delicate garments.
When selecting an exclusively time-based drying function, a drying cycle is
performed at the end of the wash cycle that is particularly delicate, thanks
to light handling and appropriate temperature control of the water jet.
The recommended durations are:
1 kg of synthetic garments --> 150 min
1 kg of synthetic and cotton garments --> 180 min
1 kg of cotton garments --> 180 min
The degree of dryness depends on the load and fabric composition.
Wool - Woolmark Apparel Care - Blue:
The "Wool" wash cycle is approved by the Woolmark
Company for washing wool garments classified as
"hand-washable", provided that the wash complies with
the instructions appearing on the garment's label and
with those provided by the manufacturer of this washer-
dryer. (M1318)
Rapid 30': this programme is designed to wash lightly soiled garments at
30° (excluding wool and silk) with a 3 kg maximum load in a short time: it
only lasts 30 minutes and allows for saving time and
Cotton 90°+P: suitable for resistant linen and cotton that are heavily soiled.
Standard Cotton 60°C: suitable for washing moderately soiled cotton
garments. At 60°C it is the standard cycle for washing cotton garments,
and is the most efficient in terms of combined water and electricity
consumption.
Synthetic: suitable for washing moderately soiled garments made of
synthetic fibres (e.g. polyester, polyacrylic, viscose, etc.) or mixed
synthetic-cotton fibres.
Coloured: a 30°C cycle that helps to preserve colours, suitable for cotton
or synthetic coloured garments. It allows for reducing electricity
consumption for heating the water while guaranteeing
results. Suitable for lightly soiled garments.
Eco Cotton 20°: ideal for lightly soiled cotton loads. The effective
performance levels achieved at cold temperatures, which are comparable
to washing at 40°, are guaranteed by a mechanical action which operates
at varying speed, with repeated and frequent peaks.
Eco Synthetic: ideal for mixed loads (cotton and synthetics) with a
normal soil level. The effective performance levels achieved at cold
temperatures are guaranteed by a mechanical action which operates at
varying speed, across set average intervals.
Wash&Dry 45': select programme 13 for washing and drying lightly
soiled garments (Cotton and Synthetic) in a short time. This cycle may be
used to wash and dry a laundry load of up to 1 kg in just 45 minutes. To
achieve optimum results, use liquid detergent and pre-treat cuffs, collars
and stains.
AirFresh: ideal cycle to refresh garments and remove bad odours, in
particular smoke, from cotton and synthetic items in 30' (max. 1,5 kg)
without the washing phase.
Rinse/Bleach: designed for rinsing and
Spin + Drain: designed to spin and drain the water.
DISPLAY
The display is useful when programming the machine and provides a lot
of information.
B
A
The duration of the available wash cycles and the remaining time of a
running cycle appear in section A; if the Delayed Start option has been
". Max. load: 3 kg.
energy.
good washing
bleaching.
C
D
set, the countdown to the start of the selected cycle will appear.
Pressing the corresponding button allows you to view either the
maximum spin speed, temperature and drying time values attained by
the machine during the set wash cycle, or the values selected most
recently (if compatible with the set wash cycle).
The hourglass flashes while the machine processes the data on the basis of the
selected cycle. After a maximum of 10 minutes, the
and the final time remaining is displayed. The "hourglass" icon will then switch
off approximately 1 minute after the final time remaining has been displayed.
The "washing phases" relative to the selected cycle and the "washing
phase" of the running cycle appear in section B:
Wash
Rinse
Spin/ Drain
Drying
When lit, the symbol
indicates that the set "Delayed Start" value has
appeared on the display.
There are three levels in section C relative to the washing options.
Section D includes the icons related to the three different drying levels as
well as the icon
, which lights up when a timed drying option is set.
Door locked indicator
When lit, the symbol indicates that the door is locked. To prevent any
damage, wait until the symbol turns off before opening the door.
To open the door while a cycle is in progress, press the START/PAUSE
button
; if the
symbol is off, the door can be opened.
FIRST-TIME USE
Once the appliance has been installed, and before it is used for the first
time, run a wash cycle with detergent and no laundry, by setting the
"Auto-Clean" cycle.
DAILY USE
Prepare the laundry by following the suggestions appearing under the
"TIPS AND SUGGESTIONS" section.
Rapid programming
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in "DETERGENT DISPENSER DRAWER"
section.
- Close the door.
- Press the PUSH & WASH + DRY button to start the wash cycle.
Traditional programming
- Press the ON/OFF button
; the START/PAUSE indicator light
flash slowly green.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the Wash Cycle Table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in "DETERGENT DISPENSER DRAWER"
section.
- Close the door.
- Use the WASH CYCLE selector knob to select the desired wash cycle: it
will be associated with a specific temperature and spin speed that can be
modified. The duration of the cycle will appear on the display.
- Modify the temperature and/or spin speed: the machine automatically
displays the maximum temperature and spin speed values set for the
selected cycle, or the most recently-used settings if they are compatible
with the selected cycle. Pressing the
temperature down to the cold wash "OFF" setting. Pressing the
gradually reduces the spin speed until it is completely excluded ("OFF"
setting). Pressing
these buttons again restores the maximum values.
- Select the desired options.
- Press the
START/PAUSE
button to start the wash cycle; the relative
indicator light will light up steady green and the door will lock (
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE
indicator light will flash amber. If the
opened. To start the wash cycle from the point at which it was
interrupted, press the START/PAUSE
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the
symbol turns on to signal that the door cannot
be opened. While a wash cycle is running, the door remains locked. To
open the door while a cycle is under way, for example, to add or remove
garments, press the START/PAUSE
indicator light will flash amber. If the
opened. Press the START/PAUSE
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washer-dryer using the
START/PAUSE
button (the relative indicator light will flash amber), then
select the desired cycle and press the START/PAUSE
! To cancel a cycle that has already begun, press and hold the ON/OFF
button. The cycle will be stopped and the machine will switch off.
END OF THE CYCLE
This will be indicated by the word "END" on the display; when the
switches off, the door may be opened. Open the door, unload the laundry
and switch off the machine.
If you do not press ON/OFF
washer-dryer will switch off automatically after about a half of an hour.
icon remains steady lit
button gradually reduces the
symbol on).
button again; the
symbol is not lit, the door may be
button again.
button to pause the cycle; the
symbol is not lit, the door may be
button again to continue the cycle.
button again.
button, the
will
button
symbol