AEG ARCTIS Manual de Instruções - Página 8

Electrical Connection

The plug socket necessary for connection of your appliance to the

electricity supply should be positioned so that it is possible to pull out

the appliance plug.

A concealed protective contact plug socket requires 10 A/16 A fusing.

If the socket is not accessible, the electrical installation must include

suitable means of isolating the appliance from the mains (e.g. fuse,

cut-out, current trip or similar with a minimum contact separation of

3 mm).

Before initial start-up, refer to the appliance serial plate to ascertain if

supply voltage and current values correspond with those of the mains

at the installation location.

e.g.: AC 220 ... 240 V

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance on the left.

The side at which the door opens can be changed from the right side

(as supplied) to the left side, if the installation site requires.

Warning! When changing the side at which the door opens, the appli-

ance must not be connected to the mains. Remove plug from the

mains beforehand.

Tilt the appliance slightly towards the

rear and prop it securely.

Unscrew the door hinge screws (K)

and remove the hinge pin bracket (1).

Open the door a little way and take it

out downwards.

220 ... 240 V

50 Hz or

~50 Hz

AEG97