A-Neuvideo ANI-7251TX Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Extensor A-Neuvideo ANI-7251TX. A-Neuvideo ANI-7251TX 12 páginas. Hdmi over cat5e/6/7 extender w/ lan/ir/rs-232/poe transmitter & receiver

Imprimir página
A
NEUVIDEO
Transmitter
front
DC 48V:
Plug the 48V DC power supply into the unit and connect the adaptor to an AC outlet.
q
IR1 BLASTER:
Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR Blaster in direct line-of-sight of the
w
equipment to be controlled.
IR2 EXTENDER:
Connect to the supplied IR Extender cables for IR signal reception. Ensure that remote being used is within the direct
e
line-of-sight of the IR Extender.
CAT5E/6/7 OUT:
Connect to the Receiver unit with a single CAT5e/6/7 cable for transmission of all data signals.
r
HDMI IN:
Connect to HDMI source equipment such as a DVD or Blu-ray player.
t
STD/UPDATE SWITCH:
y
RS-232 IN:
Connect to a PC or Laptop with D-Sub 9-pin male cable for the transmission of RS-232 commands.
u
LAN:
Connect to an internet or network system.
i
POWER LED:
This LED will illuminate when the device is connected to a power supply.
o
LINK LED:
This LED will illuminate when both Transmitter and Receiver are connected through CAT cable. When it blinks regularly it
a
states the Transmitter is NOT sending signal but the Transmitter and Receiver are linked and if it blinks irregularly it states an error has
occurred.
This switch is reserved for factory use only.
Operation controls & Functions
back
5