A-Neuvideo ANI-9251RX Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Extensor A-Neuvideo ANI-9251RX. A-Neuvideo ANI-9251RX 12 páginas. Hdcp 2.2 & hdmi 2.0 extender with oar / audio insertion for use with the ani-1082uhd
Também para A-Neuvideo ANI-9251RX: Manual de instruções (12 páginas)

Imprimir página

NEUVIDEO

Front Panel

POWER LED:

This power LED will illuminate when receiving power from the transmitter.

OPTICAL IN:

Connects with an optical audio source as an optical audio return which sends audio to the Transmitter.

IR IN 1:

IR IN 1 is considered an IR receiver which connects to the supplied IR Receiver cables for IR signal reception. Ensure that

remote being used is within the direct line-of-sight of the IR Extender.

IR OUT 2:

IR Out 2 is considered an IR BLASTER which connects to the supplied IR Blaster cable for IR signal transmission. Place

the IR Blaster in direct line-of-sight of the equipment to be controlled.

RS-232:

Connects to the device that is to be controlled (via RS-232 terminal connected with a D-Sub 9-pin cable) by ASCII commands.

UPDATE:

When updating the firmware, the switch should be moved to the left side. As indicated by the arrows on the case.

BACK Panel

CAT5E/6/7 IN:

Connects to the transmitter unit with a single CAT5e/6/7 cable for transmission of all data signals and power.

HDMI OUT:

Connects to the HDMI sink equipment such as a display.

LAN:

Connects to your local LAN or device.

Operation controls & Functions