Kohler 1.1785.001 Manual de instalação - Página 10
Procurar online ou descarregar pdf Manual de instalação para Luminárias de casa de banho Kohler 1.1785.001. Kohler 1.1785.001 41 páginas. Thermostatic electric shower
Imprimir página
Tools Required
Installation Requirements
General
We recommend that the product be brought into the room where it is to be installed
and left to acclimatise to room temperature, this will reduce the possibility of
condensation on electronic components.
The shower works best when water supply conditions are stable and within the
specifications, refer to section 'Specifications'. If the supply conditions fall outside
the specifications, the shower may go into a safe shut down condition.
DO NOT connect the outlet of the shower to any tap, on/off control valve, trigger
operated showerhead or any other showerhead other than those specified for use
with this shower. This could cause scalding or severe damage to the product and
will invalidate the guarantee. Only Kohler Mira recommended showerheads, shower
hoses and accessories must be used.
If pipework and/or electrical cables enter the shower from the rear through a hole in
the wall, provision must be made to prevent water ingress back into the wall structure.
Route cable and pipe supplies via the cut outs moulded in the case and cover.
DO NOT perform any unspecified modifications to the shower or its accessories.
Drilling fixing holes or making water or electrical entry points outside of the showers
designed areas can lead to uncontrolled water ingress. This could cause fire,
electrocution or damage to the product and will invalidate the product guarantee.
When servicing only use genuine Kohler Mira replacement parts.
DO NOT increase the size or cut alternative pipe / cable entry points as water ingress
into the product may occur.
After completing the installation be careful when cleaning. Many household and
commercial cleaners, including tile cleaners and hand/surface cleaning wipes contain
abrasives and chemical substances that can damage plastics, plating and printing
and should not be used. These finishes should be cleaned with a mild washing up
detergent or soap solution, and then wiped dry using a soft cloth.
1306246-W2-D
6.0 mm
10