A-Neuvideo ANI-2PIP-LOGO Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Monitor A-Neuvideo ANI-2PIP-LOGO. A-Neuvideo ANI-2PIP-LOGO 15 páginas. 2x1 hdmi multiviewer
Também para A-Neuvideo ANI-2PIP-LOGO: Manual de instruções (20 páginas)

Imprimir página

OPERATION CONTROLS & FUNCTIONS

Front Panel

q SERVICE:

This port is reserved for firmware update use only.

w POWER LED:

This LED will illuminate to indicate the unit is on and receiving power.

e SWITCH BUTTON:

Press to toggle between the (2) HDMI inputs and output the selected source

full screen.

NOTE: Press and hold this button for 2 seconds to change the output resolution to 1920x1080p@60Hz.

r MODE BUTTON:

Press to sequentially switch between the Full Screen (NONE), Picture-in-Picture

(PIP), Side-by-Side (SBS), and Picture-outside-Picture (POP) windowing modes.

NOTE: Press and hold this button for 2 seconds to change the output resolution to 1024x768@60Hz.

t AUDIO BUTTON:

Press to toggle between the audio from the (2) HDMI inputs.

y INFO. BUTTON:

Short press to show the current input/output resolution status, audio selection

and IP information. Long press to show the current contrast, brightness, hue, sharpness, color

format, chroma and color temperature settings for each source channel.

OPERATION CONTROLS & FUNCTIONS

BACK Panel

q AUDIO OUT:

Connect to powered speakers or an amplifier for balanced stereo analog audio

output.

w HDMI OUT:

Connect to an HDMI TV, monitor or amplifier for digital video and audio output.

e TRIGGER IN:

This 10 pin terminal block provides (8) trigger pins (plus 5V & Ground) for activating

pre-designated functions within the unit. Compatible with the optional Trigger Keypad unit.

Pins are numbered from left to right:

TOP ROW

Vcc (5V)

POP Windowing Mode

SBS Windowing Mode

PIP Windowing Mode

Full Screen Window (Toggle)

r HDMI IN 1~2:

Connect to HDMI source equipment such as media players, game consoles or

set-top boxes.

t RS-232:

Connect directly to a PC, laptop or other serial control device to send RS-232 commands

to control the unit.

y CONTROL:

Connect directly, or through a network switch, to your PC/laptop to control the unit

via Telnet/WebGUI.

u DC 5V:

Plug the 5V DC power adapter into the unit and connect it to an AC wall outlet for power.