AEG 7000 Series Manual do utilizador - Página 38
Procurar online ou descarregar pdf Manual do utilizador para Secador AEG 7000 Series. AEG 7000 Series 44 páginas.
Também para AEG 7000 Series: Manual do utilizador (32 páginas), Manual do utilizador (49 páginas), Manual do utilizador (32 páginas), Manual do utilizador (28 páginas), Manual do utilizador (36 páginas)
Imprimir página
38
www.aeg.com
•
- The mains supply is unstable.
Wait until the mains supply is stable.
•
- No communication between
electronic elements of the appliance.
Switch it off and switch on again.
16.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance fills with
water and drains immedi-
ately
•
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the Start/Pause has been touched.
• If the delay start is set, cancel the setting or wait for the end
of countdown.
• Deactivate the Child Lock function if it is on.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is
correct.
• Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to 'Care and cleaning'.
• Make sure that the drain hose is in the correct position. The
hose may be positioned too low. Refer to "Installation in-
struction".
The programme was not finished
properly or the appliance stopped
too early. If the alarm code appears
again, contact the Authorised Service
Centre.
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before carrying out any
check.