Kohler K-1257 Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para Luminárias de casa de banho Kohler K-1257. Kohler K-1257 44 páginas. Bath whirlpool
Também para Kohler K-1257: Manual do Proprietário (32 páginas), Manual do Proprietário (29 páginas), Manual de instalação (48 páginas), Manual do Proprietário (36 páginas), Manual do Proprietário (32 páginas), Manual de instalação (48 páginas), Manual de montagem (4 páginas), Manual de montagem (4 páginas), Manual de instalação (48 páginas), Manual de montagem (4 páginas), Manual de instalação (48 páginas), Manual de instalação (44 páginas), Manual do Proprietário (29 páginas), Manual de montagem (4 páginas), Manual de instalação (48 páginas)

1. Prepare the Site

NOTICE: Unless otherwise speciﬁed, ﬂoor support under the whirlpool must provide for a minimum of

80 lbs./square foot (390 kg/square meter) loading.

NOTICE: Do not support the whirlpool by the rim.

Make sure the ﬂooring offers adequate support for your whirlpool, and verify that the subﬂoor is

ﬂat and level.

The whirlpool should be installed in a drop-in installation. Construct 2x4 or 2x6 stud framing

designed for your particular installation. Provide for a 1/16" (2 mm) gap between the bottom of the

whirlpool rim and the stud framing. Frame the ﬂoor, or construct a frame for a raised installation in

accordance with the roughing-in information packed with the whirlpool.

Carefully lay out and cut the rough deck material. Use the cut-out template if one is provided, or

refer to the roughing-in cut-out information.

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

Install the drain to the whirlpool according to the drain manufacturer's instructions. Do not connect

the trap at this time.

Position a clean drop cloth or similar material in the bottom of the whirlpool. Be careful not to

scratch the surface of the whirlpool.

Kohler Co.

Position the rough

plumbing.

Construct 2x4 or 2x6

stud framing according

to the roughing-in

information.

Provide a 1/16" (2 mm) gap

between the whirlpool rim

and framing.

Frame the floor

according to the

roughing-in information.

Verify that the subfloor

offers adequate support,

and is flat and level.

1010914-2-D