AEG Lavatherm 76280AC Manual do utilizador - Página 22
Procurar online ou descarregar pdf Manual do utilizador para Secador AEG Lavatherm 76280AC. AEG Lavatherm 76280AC 28 páginas.
Também para AEG Lavatherm 76280AC: Manual do utilizador (36 páginas), Manual do utilizador (24 páginas), Manual do utilizador (28 páginas)
Imprimir página
22 www.aeg.com
• When the appliance is put in its per-
manent position, check it is fully level
with the aid of a spirit level. If it is not,
adjust the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through
thick carpets, plank of wood or piece
of wood. This can increase the heat
which can cause interference with the
operation of the appliance.
• The temperature of the hot air
• When the tumble dryer oper-
• If it is necessary to move the
• The appliance must not be in-
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm
13.2 Unpacking
CAUTION!
insde the tumble dryer can ex-
ceed 60 °C. The appliance
must not be installed on the
floor which is not resistant to
high temperatures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
appliance, it must be moved
vertically.
stalled behind a lockable door,
a sliding door, a door with a
hinge on the opposite side to
that of the appliance in such a
way that a full opening of the
tumble dryer is restricted.
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1.
Open the load door.
2.
Pull plastic hose with the polystyrene
blockages out from the drum.
13.3 Installation under a
counter
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
600 mm
600 mm
> 850 mm
13.4 The load door reversal
The load door can be installed by the
user in the opposite side. It can help to
easily put and remove the laundry or if
there is a limit to install the appliance.
(see separate leaflet).
13.5 Electrical connection
• Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
• Make sure that the electrical data on
the rating plate agrees with the power
supply.
• Always use a correctly installed shock-
proof socket.