Kohler BATH WALL Manual de instruções de instalação - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação para Banheiras Kohler BATH WALL. Kohler BATH WALL 9 páginas. Bath with airjets
Também para Kohler BATH WALL: Manual de montagem (4 páginas)
Imprimir página
DURACRYL WALL
DURACRYL WALL INSTALLATION
1. PREPARING WALL AND SPACE
Ensure the shower tray or bath tub is installed
correctly, as detailed in the installation guide
supplied with the product. Peel back protective
film of the tiling bead of shower tray or bath
in order to make a water tight seal possible.
Ensure the surface of tray or bath tub is
protected during installation, and no debris
can get into the waste hole. For bath tubs use
a drop cloth.
For shower trays, select appropriate size, then
cut base protector from back of shower tray
carton. Place it in shower tray as per figure 6.
Fig.6: Cutting base protector
Mark and drill holes required for outlet fittings
as per figure 7. .
NOTE: Follow the drilling and cutting
instructions from page 3.
Fig.7: Mark and drill holes for plumbing
INSTALLATION INSTRUCTIONS
Position wall in place. Check fit to ensure wall
fits squarely into corner as per figure 8. Tape
edges to hold into position.
Fig.8: Positioning wall
Where necessary (bath) notch the edge of wall
to fit over the tiling bead as shown in figure 9.
Fig.9: Bath tub notching
Before marking, make sure the wall is pressed
firmly into the corner of wall.
With a soft pencil, mark around the perimeter of
the wall liner. This will be the basis for marking the
glue pattern as per figure 10.
Fig.10: Marking liner edge onto wall board
Page 6
Bath wall liner
Tiling bead (upstand)
ENGLEFIELD