Fill with water at least 2" (5.1 cm)
above the highest jet.
Turn the jet trim ring
clockwise to
decrease the flow.
Turn the jet trim ring counterclockwise
to increase the flow.
Operating Your Whirlpool
Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully
counterclockwise.
NOTE: The water temperature in the whirlpool should never exceed 104°F (40°C).
Close the drain, and fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.
Use your hand to test the water temperature for comfort and safety, then carefully enter the bath
basin.
Press the air actuator to turn on the whirlpool.
NOTE: If equipped, the heater will also turn on.
Adjust the jets for optimum air/water mixture. Turn the jet trim rings clockwise to reduce the flow,
and counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired
to maximize your hydro-massage experience.
Press the air actuator a second time to turn off the whirlpool.
Carefully exit the bath, and open the drain to empty the whirlpool.
NOTE: If your whirlpool includes an optional timer kit, the whirlpool will turn off after approximately 20
minutes of continuous operation. You can then restart the whirlpool if you desire by pressing the air
actuator.
NOTE: If the whirlpool does not function properly, please refer to the Troubleshooting section.
Cleaning Your Whirlpool
For best results, keep the following in mind when caring for your KOHLER product:
• Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not use
abrasive cleaners that may scratch or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Do not allow cleaners to sit or soak on the surface.
• Wipe surfaces clean and rinse completely with water immediately after cleaner application. Rinse
and dry any overspray that lands on nearby surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
1010564-5-J
Position the jet
nozzles to direct
the water flow as
desired.
4
Press the air switch to turn the
whirlpool on or off.
Kohler Co.
Imprimir página