Kohler K-1131 Manual de instalação - Página 9

Procurar online ou descarregar pdf Manual de instalação para Banheiras Kohler K-1131. Kohler K-1131 44 páginas. Bath whirlpool
Também para Kohler K-1131: Manual do Proprietário (32 páginas), Manual de instalação (48 páginas), Manual de instalação (44 páginas), Manual de instalação (48 páginas)

Install a GFCI- or RCD-protected 120 V, 15 A grounded outlet. Install

a second GFCI- or RCD-protected outlet for "H" models for the heater.

Optional Heater (models may vary)

either T-style (shown) or water intake

(not shown).

Make sure air actuator tubing

is securely attached to the pump.

Bond in accordance with applicable codes.

8. Make Electrical Connections

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

WARNING: Risk of electric shock. Connect the pump and in-line heater (if included) to properly

grounded, grounding-type receptacles protected by Ground-Fault Circuit-Interrupters (GFCI's) or

Residual Current Devices (RCD's). Do not remove the grounding pins from the plug. Do not use

grounding adapters.

NOTE: A label identifying the model number and electrical rating of the whirlpool is located near the

whirlpool pump.

NOTICE: The pump (supplied) and heater (if supplied) are equipped with a cord and plug. All wiring for

the heater has been completed at the factory. A qualiﬁed electrician must install a GFCI- or RCD-protected,

120 V, 15 A, grounded outlet. No other load should be on this circuit.

Pump Wiring

Locate the outlet behind the whirlpool, and within 24" (61 cm) of the pump.

Plug the pump into this outlet.

NOTE: Make sure the air actuator tubing is securely attached to the pump, and is not kinked or damaged.

Heater Wiring – "H" Models

Locate the outlet behind the whirlpool, and within 24" (61 cm) of the heater.

Plug the heater into this outlet.

Check all electrical connections, and make sure the electrical power to the whirlpool and heater (if

equipped) is on.

Make sure all union connections to the pump and heater are securely hand tightened.

Verify that the pump banding straps have been cut (if applicable), and that the pump is resting

directly on the subﬂoor or whirlpool base.

Fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet. Refer to "Conﬁrm

Proper Operation" section for additional information.

Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

Kohler Co.

NOTE: Pump model illustrated may differ from your actual product.

Plug pump and heater

into these outlets.

1011092-2-F