Kohler VEIL K-5402A-0 Manual do Proprietário - Página 8
Procurar online ou descarregar pdf Manual do Proprietário para Casas de banho Kohler VEIL K-5402A-0. Kohler VEIL K-5402A-0 20 páginas. Veil intelligent toilet
Também para Kohler VEIL K-5402A-0: Manual de instruções de instalação (26 páginas), Manual do Proprietário (20 páginas)
Imprimir página
On the side of toilet, press and hold the
simultaneously. Release button, then change settings according to below B/C/E/F/O.
–
•
Press and hold this button to set auto cover detection distance
1.
Night light quick blink once is close distance (short beep)
2.
Night light quick blink twice is middle distance (short beep)
3.
Night light quick blink three times is far distance (short beep)
4.
Night light slow blink once to turn off auto cover open function (long beep).
–
Press and hold this button to set deodorizer function ON/OFF status
•
Night light quick blink once indicate deodorizer functions is ON (short beep)
1.
Night light slow blink once indicate deodorizer functions is OFF (long beep)
2.
–
•
Press and hold this button to set auto flush function ON/OFF status.
Night light quick blink once to activate auto flush function (short beep)
1.
Ni
gh
t light slow blink once to deactivate auto flush function (lon
2.
–
•
Press and hold this button to set energy saving function ON/OFF status.
1.
Night light quick blink once to activate energy saving function (short beep)
2.
Night light slow blink once to deactivate energy saving function (long beep).
–
•
Press and hold this button to set auto sterilization function ON/OFF status.
1.
Night light quick blink once to activate auto sterilization function (short beep)
2.
Night light slow blink once to deactivate auto sterilization function (long beep)
–
•
Press and hold manual clean wand function under unseated status to extend wand to perform manual clean on nozzle.
Press and hold this button again or press STOP button to deactivate this function.
Remote Battery Usage and Exchange
•
Remote docking station uses 4x AA alkaline batteries.
•
When battery is low, red LED blinking on docking station indicates
user is required to change battery.
•
To remove docking station from wall bracket:
1) Lift dock upwards
Others
•
Do not place remote in water or in a location where water may be splashed on the remote.
•
Do not place remote near a heater, dryer or any appliance that may cause interference to the normal operation of remote.
•
Place remote back on docking station after each use.
•
Avoid dropping or rough handling of the remote.
•
Guarding function: the remote can be locked with docking station. Refer to the instruction manual for this specific method.
1274372-A05-B
June 2016
button until you hear one short beep. Night light shall blink 3 times
2) Shift dock sideways
g beep)
3) Remove dock
8
Red light blink
1. Batteries +/- poles must be oriented
as shown in diagram on the remote.
2.
Do not mix new and old batteries.
3. Please use alkaline batteries.
Kohler Co.