Kohler 18-26 Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Motor Kohler 18-26. Kohler 18-26 21 páginas. Command 18-26 hp horizontal crankshaft

Imprimir página

Choke

Control

Figure 6. Optional Engine Mounted Throttle and

Choke Controls (CH18-25).

2. Start the engine by activating the key switch.

Release the switch as soon as the engine starts.

NOTE: Do not crank the engine continuously for

more than 10 seconds at a time. If the

engine does not start, allow a 60 second

cool down period between starting

attempts. Failure to follow these

guidelines can burn out, or permanently

damage, the starter motor.

NOTE: Upon start up, a metallic ticking may

occur. This is caused by the hydraulic

lifter leakdown during storage. Run the

engine for 5 minutes. The noise will

normally cease in the first minute. If noise

continues, run the engine at mid-throttle

for 20 minutes. If noise persists, take the

engine to your local authorized Kohler

Engine Service Dealer.

If the engine develops sufficient speed to

disengage the starter but does not keep running (a

false start), the engine rotation must be allowed to

come to a complete stop before atttempting to

restart the engine. If the starter is engaged while

the flywheel is rotating, the starter pinion and

flywheel ring gear may clash resulting in damage to

the starter.

If the starter does not turn the engine over, shut off

starter immediately. Do not make further attempts

to start the engine until the condition is corrected.

Do not jump start using another battery (refer to

"Battery" on this page). See your Kohler Engine

Service Dealer for service assistance.

CH18-25 Engines Only:

3. For a Cold Engine – Gradually return the choke

control to the "off" position after the engine starts

and warms up.

The engine/equipment may be operated during the

warm up period, but it may be necessary to leave

the choke partially on until the engine warms up.

4. For a Warm Engine – Return choke to "off"

position as soon as engine starts.

Stopping

1. Remove the load by disengaging all PTO driven

Throttle

attachments.

Control

2. For CH18-25 Engines Without A Shutdown

Solenoid: Move the throttle to the "slow" or

"low" idle position. Allow the engine to run at idle

for 30-60 seconds; then stop the engine.

For CH18-25 Engines Equipped With A

Shutdown Solenoid: Position the throttle control

somewhere between half and full throttle; then stop

the engine.

For CH26 Engines: Turn key ''off'' to stop

engine.

Battery

A 12 volt battery is normally used. Refer to the

operating instructions of the equipment this engine

powers for specific battery requirements.

If the battery charge is not sufficient to crank the

engine, recharge the battery (see page 12).

Operating

Angle of Operation

This engine will operate continuously at angles up to

25°. Check oil level to assure crankcase oil level is at

the "F" mark on the dipstick.

Refer to the operating instructions of the equipment this

engine powers. Because of equipment design or

application, there may be more stringent restrictions

regarding the angle of operation.

NOTE: Do not operate this engine continuously at

Cooling

NOTE: If debris builds up on the grass screen or other

angles exceeding 25° in any direction. Engine

damage could result from insufficient

lubrication.

cooling air intake areas, stop the engine

immediately and clean. Operating the engine

with blocked or dirty air intake and cooling

areas can cause extensive damage due to

overheating.