Kohler COMMAND CV-675-740 Manual do Proprietário - Página 11

Procurar online ou descarregar pdf Manual do Proprietário para Motor Kohler COMMAND CV-675-740. Kohler COMMAND CV-675-740 21 páginas. Vertical crankshaft

Imprimir página

Change Oil Filter

zyxwvutsrq

Replace the oil filter at least every other oil change

(every 200 hours of operation).

zyxwvuts

Always use a

genuine Kohler oil filter, Part No. 12 050

zyxwvuts

OI-S.

Replace the oil filter as follows:

1. Drain the oil from the engine crankcase.

2. Allow the oil filter to drain.

3. Before removing the oil filter, clean the area

around the oil filter to keep dirt and debris out of

the engine. Remove the old filter. Wipe off the

surface where the filter mounts.

4. Place a new replacement filter in a shallow pan

with the open end up. Pour new oil, of the proper

type, in through the threaded center hole. Stop

pouring when the oil reaches the bottom of the

threads. Allow a minute or two for the oil to be

absorbed by the filter material.

5. Put a drop of oil on your fingertip and wipe it on

the rubber gasket.

6. Install the new oil filter to the filter adapter or oil

cooler. Turn the oil filter clockwise until the rubber

gasket contacts the filter adapter or oil cooler, then

tighten the filter an additional 2/3 to 1 turn.

Reinstall the drain plug. Make sure it is tightened

to 13.6 N-m (10 ft. Ib.) torque.

8. Fill the crankcase with new oil, of the proper type,

to the "FULL" mark on the dipstick.

9. Test run the engine to check for leaks. Stop the

engine, allow a minute for the oil to drain down,

and recheck the level on the dipstick. Make sure

oil level is up to but not over the "FULL mark on

the dipstick.

Service Precleaner and Air Cleaner Element

These engines are equipped with a replaceable, high

density paper air cleaner element. An optional heavy-

duty air cleaner system is also available. Most engines

are also equipped with an oiled, foam precleaner which

surrounds the paper element. See Figures 12 and 13.

Check the air cleaner daily or before starting the

engine. Check for a buildup of dirt and debris around

the air cleaner system. Keep this area clean. Also

check for loose or damaged components. Replace all

bent or damaged air cleaner components.

NOTE: Operating the engine with loose or damaged

air cleaner components could allow unfiltered

air into the engine causing premature wear

and failure.

Air Cleaner

Cover

Knob

Seal

Knob

Spitback Cup

Element

Cover Nut

Element

Cover

Air Cleaner Base

Cup Gasket

'igure 12. Air Cleaner System Components

Type A (Standard).