Kohler COMMAND CV12.5 Manual do Proprietário - Página 9
Procurar online ou descarregar pdf Manual do Proprietário para Motor Kohler COMMAND CV12.5. Kohler COMMAND CV12.5 17 páginas. Vertical crankshaft
Também para Kohler COMMAND CV12.5: Manual do Proprietário (16 páginas), Manual do Proprietário (16 páginas)
Imprimir página
Operating
Range
Figure 7. Oil Level Dipstick.
5. If the level is low, add oil of the proper type, up to
the "F" mark on the dipstick. (Refer to "Oil Type"
on page 4.) Always check the level with the
dipstick before adding more oil.
NOTE: To prevent extensive engine wear or
damage, always maintain the proper oil
level in the crankcase. Never operate the
engine with the oil level below the "L"
mark or over the "F" mark on the dipstick.
Oil Sentry™
Some engines are equipped with an optional Oil
Sentry™ oil pressure switch. If the oil pressure
decreases below an acceptable level, the Oil Sentry™
will either shut off the engine or activate a warning
signal, depending on the application.
NOTE: Make sure the oil level is checked BEFORE
EACH USE and is maintained up to the "F"
mark on the dipstick. This includes engines
equipped with Oil Sentry™.
Change Oil and Oil Filter
Change Oil
Change oil after every 100 hours of operation. Refill
with service class SG, SH, SJ or higher oil as specified
in the "Viscosity Grades" table (Figure 2) on page 4.
Change the oil while the engine is still warm. The oil
will flow more freely and carry away more impurities.
Make sure the engine is level when filling, checking, or
changing the oil.
Change the oil as follows (see Figure 8):
1. To keep dirt, grass clippings, etc., out of the
"F" Mark
2. Remove the oil drain plug and oil fill cap/dipstick.
3. Reinstall the drain plug. Make sure it is tightened
4. Fill the crankcase, with new oil of the proper type,
5. Reinstall the oil fill cap or plug and tighten
Oil Drain Plug
(Carb. Side)
Optional Oil Sentry™ Switch
Figure 8. Oil Drain Plugs, Oil Filter, Oil Filter Drain
Plug, and Optional Oil Sentry™ Switch.
engine, clean the area around the oil fill cap/
dipstick before removing it.
Be sure to allow ample time for complete
drainage.
to 13.6 N·m (10 ft. lb.) torque.
to the "F" mark on the dipstick. Refer to "Oil Type"
on page 4. Always check the level with the dipstick
before adding more oil.
securely.
NOTE: To prevent extensive engine wear or
damage, always maintain the proper oil
level in the crankcase. Never operate the
engine with the oil level below the "L"
mark or over the "F" mark on the dipstick.
Oil Filter
Oil Drain Plug
(Starter Side)
Optional Oil
Filter Drain Plug
9