Kohler Command Pro CV173 Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Motor Kohler Command Pro CV173. Kohler Command Pro CV173 8 páginas.
Também para Kohler Command Pro CV173: Manual do Proprietário (48 páginas)

Imprimir página

Kohler Command Pro CV173 Manual do Proprietário

Fuel Line

Low permeation fuel line must be installed on

carbureted Kohler Co. engines to maintain EPA

and CARB regulatory compliance.

Spark Plugs

Electrical Shock can cause injury.

Do not touch wires while engine

is running.

Clean out spark plug recess. Remove plug and

replace.

1. Check gap using wire feeler gauge. Adjust

gap, see speciﬁ cation table for adjustment.

2. Install plug into cylinder head.

3. Torque plug to 20 ft. lb. (27 N·m).

Air Cleaner

NOTE: Operating engine with loose or

damaged air cleaner components

could cause premature wear and

failure. Replace all bent or damaged

components.

NOTE: Paper element cannot be blown out

with compressed air.

Move bails on air cleaner cover down; remove

latches from under tabs on base; remove cover.

Precleaner:

1. Remove precleaner from paper element.

2. Replace or wash precleaner in warm water

with detergent. Rinse and allow to air dry.

3. Lightly oil precleaner with new engine oil;

squeeze out excess oil.

4. Reinstall precleaner over paper element.

Paper Element:

1. Separate precleaner from element; service

precleaner and replace paper element.

2. Install new paper element on base; install

precleaner over paper element.

Reinstall air cleaner cover and place latches

under tabs on base; lift up bails to secure cover.

Breather Tube

Ensure both ends of breather tube are properly

connected.

14 590 48 Rev. A

CAUTION

KohlerEngines.com

Air Cooling

Hot Parts can cause severe

burns.

Do not touch engine while

operating or just after stopping.

Never operate engine with heat shields or

guards removed.

Proper cooling is essential. To prevent over

heating, clean screens, cooling ﬁ ns, and other

external surfaces of engine. Avoid spraying

water at wiring harness or any electrical

components. See Maintenance Schedule.

Repairs/Service Parts

We recommend that you use a Kohler

authorized dealer for all maintenance,

service, and replacement parts for engine.

To ﬁ nd a Kohler authorized dealer visit

KohlerEngines.com or call 1-800-544-2444

(U.S. and Canada).

Storage

If engine will be out of service for 2 months or

more follow procedure below.

1. Add Kohler PRO Series fuel treatment or

equivalent to fuel tank. Run engine 2-3

minutes to get stabilized fuel into fuel system

(failures due to untreated fuel are not

warrantable).

2. Change oil while engine is still warm from

operation (NOT required if using KOHLER

PRO 10W-50 full-synthetic oil). Remove

spark plug(s) and pour about 1 oz. of engine

oil into cylinder(s). Replace spark plug(s) and

crank engine slowly to distribute oil.

3. Store engine in a clean, dry place.

WARNING