Kohler KD 500 Manual de oficina - Página 32
Procurar online ou descarregar pdf Manual de oficina para Motor Kohler KD 500. Kohler KD 500 44 páginas. 51267
13
Engine assembly
52
53
54
55
- 32 -
Timing system cover pre-assembly
Prepare the cover of the timing system in the following way:
1. Mount the main bearing as indicated at page 18.
2. Fit in the pin and drive shaft bearing ring (fig 52).
3. Mount the oil pump rotors as described at page 23. Insert the
plug and driving pin as shown in fig. 53 - A. Fix the oil pump
cover in place by tightening the screws to the following torque
value:
0,8 ÷ 1,0 kgm (7,8 ÷ 9,8 Nm)
4. Insert the by-pass valve using tool code 00366R0210 (fig. 54);
mount the by-pass check screw with Loctite 648; mount the
bypass valve inspection plug on the outside of the cover on
the timing system side.
5. Fit the retainer cap on the oil intake duct at the base of the
cover on the timing system side, using Loctite 648 (fig. 53 -
B).
6. Tighten the internal oil filter (fig. 53 - C).
7. Fit on the engine oil filter and relative plug including the
O-Ring (fig 53 - D).
8. Mount the rpm governor, in compliance with the alphabetical
sequence given in fig. 55.
9. Fit in the fuel flow limiter
10. Mount the oil retention ring as indicated on page 35 fig.66.
Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00