ACADIA LIVING Vintage L Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Mobiliário de interior ACADIA LIVING Vintage L. ACADIA LIVING Vintage L 2 páginas. Outside mount 4 sides

Imprimir página
Step 1: Assemble the Frame
1.
Carefully remove panels and frames from the packaging.
All frame parts are labeled (top, bottom, left, and right).
2.
Remove frame inserts and place them away from the
installation area.
3.
Set all frames on a soft, level surface (moving blankets or some type of pad works best).
Position each side of the frame and line up the Dovetail Key slot.
※ If not installing with T-POST, skip to #5.
4. The top and bottom of the T-post are labeled. Locate and identify.
Line up the pre-drilled holes with the top and bottom frame and secure
with screws provided.
Fasten the T-post with additional nails if necessary.
!
The T-post connector provides some wiggle room: make sure
the T-post is at the center position at each end and secure with
two screws. The T-post can also be adjusted when gaps
between panels are not even.
5.
Insert the Dovetail Key into each slot at the back of the frame. Use a rubber mallet if necessary.
1
2
!
The Dovetail Key has a rounded side and a flat side.
The rounded side should be inserted in slot first.
Step 2 : Level the Frame
Position the assembled frame evenly
around the window opening against
the window edges. Then secure one screw
into the upper left frame ONLY.
Once done, level the frame on the window.
Step 3 : Secure the Frame
To keep the frame level, tighten one
screw into the upper right frame.
The shutters will be fully secured in
later steps.
Frame Insert
Frame Insert
3
4
With the rounded side of the Dovetail Key facing up,
push the top frame down onto the Dovetail Key.
Version 37103-65100
Step 4 : Attach the Panels
1. 1. Place the left shutter panel in the frame, align the hinges,
and insert the hinge pin. Repeat for the right shutter panel.
If you have bi-fold panels, after attaching the far left
and/or far right panels to the frame, you will need to join
the hinges of the panels labeled P1 and P2 and insert
hinge pins. Repeat for panels labeled P3 and P4 if you
!
have these. Proper order of panels from left to right is
P1, P2, P3, P4.
2.
If panel hinges are not aligned with
frame hinges properly, then frame hinges
can be adjusted.
Please check the gap between panel and
3.
frame at the top and bottom. The gap should
be even; if not, then shift frame left to right
until the gap is even.
4.
Once even, secure a screw at the bottom
of the left frame and right frame.
Check gap between panels
5.
and adjust accordingly with
hinge spacers provided if
needed.
6.
Open and close panels to make sure
panels operate properly. Secure the
frame with screws through the rest of the
pre-drilled holes.
7.
Fasten the deadlock screw for all hinges.
Loosen frame hinge
screws, adjust frame
hinges properly,
tighten screws.
Loosen hinge screws
Insert spacer behind
Spacer installed
on the panel
hinge, tighten screws