Kohler 12RESL Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Gerador portátil Kohler 12RESL. Kohler 12RESL 36 páginas. Residential/commercial generator sets
Também para Kohler 12RESL: Manual de instalação (40 páginas), Manual (36 páginas), Manual de operação (48 páginas), Funcionamento (48 páginas)

Imprimir página

The fuel system.

Explosive fuel

vapors can cause severe injury or

death.

Vaporized fuels are highly

explosive.

Use extreme care when

handling and storing fuels. Store fuels

in a well-ventilated area away from

spark-producing equipment and out of

the reach of children. Never add fuel to

the tank while the engine is running

because spilled fuel may ignite on

contact with hot parts or from sparks.

Do not smoke or permit flames or

sparks to occur near sources of spilled

fuel or fuel vapors. Keep the fuel lines

and connections tight and in good

condition. Do not replace flexible fuel

lines with rigid lines.

Use flexible

sections to avoid fuel line breakage

caused by vibration. Do not operate the

generator set in the presence of fuel

leaks, fuel accumulation, or sparks.

Repair fuel systems before resuming

generator set operation.

Gas fuel leaks.

Explosive fuel

vapors can cause severe injury or

death. Fuel leakage can cause an

explosion. Check the LP vapor gas or

natural gas fuel system for leakage by

using a soap and water solution with

the fuel system test pressurized to

6--8 ounces

per

square

(10--14 inches water column). Do not

use a soap solution containing either

ammonia or chlorine because both

prevent bubble formation. A successful

test depends on the ability of the

solution to bubble.

Hazardous Noise

CAUTION

Hazardous noise.

Can cause hearing loss.

Never operate the generator set

without a muffler or with a faulty

exhaust system.

Engine noise. Hazardous noise can

cause hearing loss. Generator sets

not equipped with sound enclosures

can produce noise levels greater than

105 dBA. Prolonged exposure to noise

levels greater than 85 dBA can cause

permanent hearing loss. Wear hearing

protection when near an operating

generator set.

TP-6397 4/07

Hazardous Voltage/

Moving Parts

DANGER

Hazardous voltage.

Will cause severe injury or death.

Disconnect all power sources before

opening the enclosure.

WARNING

Hazardous voltage.

Can cause severe injury or death.

Operate the generator set only when

all guards and electrical enclosures

are in place.

inch

WARNING

Hazardous voltage.

Backfeed to the utility system can

cause property damage, severe

injury, or death.

If the generator set is used for

standby power, install an automatic

transfer switch to prevent inadvertent

interconnection

normal sources of supply.

CAUTION

Welding the generator set.

Can

cause

equipment damage.

Never weld components of the

generator

set

disconnecting the battery, controller

wiring harness, and engine electronic

control module (ECM).

Moving parts.

standby

and

severe

electrical

without

first

Grounding electrical equipment.

Hazardous

voltage

can

severe injury or death. Electrocution

is possible whenever electricity is

present. Ensure you comply with all

applicable

codes

and

Electrically ground the generator set,

transfer switch, and related equipment

and electrical circuits. Turn off the main

circuit breakers of all power sources

before servicing the equipment. Never

contact electrical leads or appliances

when standing in water or on wet

ground because these conditions

increase the risk of electrocution.

Welding on the generator set. Can

cause severe electrical equipment

damage.

Before welding on the

generator set perform the following

steps: (1) Remove the battery cables,

negative (--) lead first. (2) Disconnect

all engine electronic control module

(ECM) connectors. (3) Disconnect all

generator set controller and voltage

regulator circuit board connectors.

(4) Disconnect the engine battery-

charging

alternator

connections.

(5) Attach the weld ground connection

close to the weld location.

Installing

the

battery

Hazardous

voltage

can

severe

injury

death.

ungrounded battery

charger may

cause electrical shock. Connect the

battery charger enclosure to the ground

of a permanent wiring system. As an

alternative,

install

grounding

conductor

with

conductors and connect it to the

equipment grounding terminal or the

lead on the battery charger. Install the

battery charger as prescribed in the

equipment manual. Install the battery

charger in compliance with local codes

and ordinances.

Connecting the battery and the

battery charger. Hazardous voltage

can cause severe injury or death.

Reconnect

the

battery

positive to positive and negative to

negative, to avoid electrical shock and

damage to the battery charger and

battery(ies).

Have

electrician install the battery(ies).

Short

circuits.

voltage/current can cause severe

injury or death. Short circuits can

cause bodily injury and/or equipment

damage.

Do not contact electrical

connections with tools or jewelry while

making

adjustments

Remove all jewelry before servicing the

equipment.

Safety Precautions and Instructions

cause

standards.

charger.

cause

equipment

circuit

correctly,

qualified

Hazardous

repairs.