AQC MAXIPLY DMP-170S Manual do Proprietário - Página 8
Procurar online ou descarregar pdf Manual do Proprietário para Coletor de pó AQC MAXIPLY DMP-170S. AQC MAXIPLY DMP-170S 20 páginas. Open type dust collector
Imprimir página6. Lower the filter cabinet onto the dust storage section and align the bolt holes.
7. Attach the filter cabinet to the dust storage section using the supplied nuts,
washers and bolts. Tighten bolts for an adequate seal.
7.2
Installation and assembly
Figure 3
1. Prepare the area where the dust collector
is to be installed and should be free of
obstacles
2. Assemble the support legs on dust hopper
and in sequence as shown. Leg # 1 is
installed front left, leg # 2 front right and
legs # 3 and 4 are at the back of the unit.
Attach the assembly with the fasteners
supplied.
3. Install the cross braces (3 pieces # 4) on
the bottom section of the support legs.
Use the fasteners supplied.
8
Support
plates
Support
legs
Cross braces
MAXITUBE
Multiple pocket type dust collector
SUPPORT
Figure 4
LEG #3
AND 4
Unside bag
removal
Figure 4 : Assembly step 2
ASSEMBLY STEP 2
Figure 5
CROSS BRACES #4
Figure 5 : Assembly step 3
ASSEMBLY STEP 3
SUPPORT
LEG #2
SUPPORT
LEG #1
Page | 9