a-TroniX 9885377 Manual de instruções - Página 9

Procurar online ou descarregar pdf Manual de instruções para Extensor a-TroniX 9885377. a-TroniX 9885377 16 páginas.

Instruction Manual
Jump starter Booster 12/24V 10000/5000A

4. How to use the emergency starter

Using the Emergency Starter to start up vehicles:
Always wear safety goggles and keep your face away from the battery when connecting it.
Check that the emergency starter is in the OFF position.
Check the voltage of the vehicle battery.
Connect the output wire with the red battery clamp (+) to the positive pole of the battery and
the output wire with the black battery clamp (-) to the negative pole of the vehicle (ground).
CAUTION:
Voltage incompatibility between the emergency starter and the voltage of the
vehicle´s electrical system can cause explosions and damage the vehicle,
product and people
CAUTION:
never switch polarity. Always connect the output conductor with a red battery
clip (+) to the positive pole of the battery and the output conductor with a black
battery clip (-) to the vehicle's earth (ground).
CAUTION:
Inverting polarity can cause explosions, damage the vehicle, product and people.
CAUTION:
If the LED RED / REVERSE is set on, the polarity has been reversed. Disconnect
the battery clips from the vehicle and connect them correctly.
CAUTION:
Check that the cables of the Emergency Starter are far away from fans, from
moving parts and from the fuel conduit.
Identify the pole corresponding to the earth of the vehicle; this is generally
connected to the negative terminal
Now PRESS „START/STOP" button blue led lit on and display show „STRT".
The led lit in correspondence of the detected voltage (12V or 24V).
If the detected voltage is 12V, but the battery is 24V, please use the „OVER
RIDE" function. (Remove the clips and follow the OVER RIDE FUNCTION
procedure)
Once the vehicle has been started up, emergency starter automatically turns
off after 30 seconds. Otherwise press START/STOP button to turn off the
emergency starter.
09/2021
Page 9