AvL Technologies SkyEdgeII Manual de interface e referência - Página 5

Procurar online ou descarregar pdf Manual de interface e referência para Modem AvL Technologies SkyEdgeII. AvL Technologies SkyEdgeII 11 páginas.

2.3. Hardware Connection

Connect the AAQ antenna controller to the SkyEdge II modem through the desired means. The AAQ controller

supports serial (RS232) and Ethernet communications to the modem and can be configured to use either depending on

the necessary networking scheme.

2.3.1.

The interfacing occurs via RS232 serial port connected to the antenna at 9600-N-8-1 baud without any authentication

or encryption in the link. Refer to section 3.1 for settings. To enable interfacing, it is not required to log in to the

SkyEdgeII modem.

2.3.2.

When setting the system to communicate by Ethernet it an Ethernet to Serial server must be used. The AAQ

Controller will be connected to the port labeled AAQ on the AvL CIP (Controller Interface Panel). The Ethernet

connection from the Ethernet to Serial server will be connected to one of the LAN ports on the CIP. The Serial

connection from the Ethernet to Serial server will connect to the Serial port on the back of the modem. To enable

interfacing, it is not required to log in to the SkyEdgeII modem.

Note: Be sure to connect power to each device.

SkyEdgeII Modem

Figure 2 – Serial Setup

Figure 3 – Ethernet Setup