Aqua Computer XT USB Manual do utilizador e de instalação - Página 6

Procurar online ou descarregar pdf Manual do utilizador e de instalação para Bomba de água Aqua Computer XT USB. Aqua Computer XT USB 20 páginas.

Imprimir página

Aqua Computer XT USB Manual do utilizador e de instalação

AQUASTREAM XT

completely into the pump housing and is not visible if the adapter is correctly in-

stalled. Excessive force may damage the pump!

Should you be using a plug-on reservoir with the pump (e. g. aquainlet), remove

the silver suction grille and mount the tank directly onto the water inlet port of the

aquastream XT pump. In this case no connecting adapter is to be installed into the

inlet port.

7. 7. 7. 7. Electrical connections

Electrical connections

7.1. Connection panel of the aquastream XT pump

The pump controller board is integrated on

the rear side of the pump. The controller

board features connectors for power supply,

fan, speed signal, aquabus interface or flow

sensor, external temperature sensor and

USB interface. Please note that depending

on the version of the pump, some connect-

ors may be without function.

ATTENTION: Completely turn off your

power supply or disconnect the mains

power cord from the wall outlet before connecting or disconnecting any cables

to/from the device!

7.2. Connector "power"

Connect a power plug of your PC's power supply unit to this connector. Do not

use excessive force but double check the polarity of the plug if you are having

trouble to connect.

Pin assignment:

Pin 1: +12 V

Pin 2: GND

Pin 3: GND

Pin 4: not connected

7.3. Connector "USB"

This connector is used for USB communication to the PC and for power supply.

Connect to an internal USB header of your motherboard. Take special care to

make sure the pin alignment matches your motherboard!

Pin assignment:

Pin 1: not connected

Pin 2: GND(black)

Pin 3: D+ (green)

Pin 4: D-

Pin 5: +5 V(red)

- 6 -

(white)

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

aqua

computer