Dexter Laundry DLC30 Series Manual do operador - Página 9

Procurar online ou descarregar pdf Manual do operador para Secador Dexter Laundry DLC30 Series. Dexter Laundry DLC30 Series 15 páginas.

Imprimir página

Once started, the "timer" cannot be stopped. However, extra coins will be acknowledged by adding time to the

display. The dryer may be stopped by opening the loading door, which interrupts the drive motor and gas burners.

Close the loading door and push

Cool-down time (owner programmable) is always part of the cycle time and is purchased by the customer. For

example, if cool-down time is 2 minutes, the last 2 minutes of the cycle will have no heat.

Credit for coins deposited, dryer time and temperature are controlled by an electronic controller.

The large digital display shows vend price of an idle dryer, time purchased after coins are deposited, temperature

and program information.

The three red indicator lights show the drying temperature selected. This selection may be made anytime.

The drying temperature will be displayed when the start switch and the switch for the selected temperature are

pressed at the same time.

All programmed data is protected from power interruption of any length and the customer's individual cycle is

protected for up to 3 seconds. This is done without batteries.

The 3 temperature buttons and the start button become programming switches when the controller is in the

program mode as described on page 10.

Some Dexter dryers are factory equipped with a card reader that is used with Dexter's Easy Card debit card system.

The card reader signals the dryer control when money is debited from the user's card account to satisfy the price of

the dry time. The dryer's pricing and the Easy Card system pricing are completely independent of each other and

must be programmed separately and coordinated. Refer to the instructions that came with the Easy Card system

for complete information.

All operating parameters (vend price, temperatures, cool-down times, etc.) are adjustable. In addition, several

displays of information are available from the controller (Money audits, hours run, dryer temperature).

The dryer is ready to run, from the factory, with the following pre-programmed data:

Temperature, HOT or HIGH:

Temperature, MEDIUM:

Temperature, WARM or LOW:

Vend Price:

Time for Left Coin:

Time for Right Coin:

Time of Free Vend:

Cool-down Time, HOT or HIGH:

Cool-down Time, MEDIUM:

Cool-down Time, WARM or LOW: 2:00 (Same as above, except WARM or LOW)

Temperature Scale

Decimal Point Display

Seconds on Display

All of the above data can be easily changed by the owner. The changes are made by the 4 keys or buttons on the

front of the control panel.

to restart the dryer.

START

DESCRIPTION OF CONTROLS

EASY CARD MODELS

PROGRAMMING:

175°F / 78°C

150°F / 63°C

125°F / 48°C

25¢

3:20 (doesn't apply to single coin models)

8:00 (8 minutes for 25¢)

8:00 ("Free Dry" cycle is 8 minutes)

2:00 (Cool-down time in HOT or HIGH is 2 minutes)

2:00 (Same as above, except MEDIUM)

F degrees

OFF