Aqua Creek Revolution Deep F-702RLNA-DD-T Manual - Página 6

Procurar online ou descarregar pdf Manual para Sistemas de elevação Aqua Creek Revolution Deep F-702RLNA-DD-T. Aqua Creek Revolution Deep F-702RLNA-DD-T 14 páginas. Draft lift

Imprimir página

ADA Fixing Insert Installation (Commercial Applications)

STEP 1: INSTALLING THE LIFT ON THE POOL/SPA DECK

1. Place the post of the main assembly into the anchor. DO NOT LIFT THE MAIN ASSEMBLY BY USING THE

ELECTRIC RAM AS A HANDLE. If the transport cart was ordered with the lift, it can be used eﬀ ectively here.

If not, use two people.

2. Mark the location for the ﬁ xing anchor hole and remove the lift.

3. Drill the hole with a 1 1/4 inch core drill or roto-hammer to a depth of about 4 1/2 inches.

4. Clean the hole out and make sure it is dry. Thread the 1/2 inch bolt into the top of the PVC ﬁ xing anchor

and test ﬁ t to verify it can be mounted perpendicular. See Step 1 below.

5. Using a two part construction epoxy, ﬁ ll the hole approximately half full and carefully insert the PVC ﬁ xing

anchor into the hole, twisting as you push down to evenly spread the epoxy.

6. Allow the epoxy to cure before securing the lift.

7. Re-install the lift into the anchor and using the 1/2 inch bolt and washer, carefully thread into the installed

anchor until snug. TO PREVENT BREAKING THE FIXING BRACKET, DO NOT OVERTIGHTEN!

1/2" X 2"

HEX BOLT

1/2" FLAT

WASHER

DECK

STEP 1

(see pg 4, FIGURE A)

MAIN ASSEMBLY

POST

ANCHOR

Revised 6/25/20