Aqua Creek Products F-EZPL2 Manual - Página 12
Procurar online ou descarregar pdf Manual para Sistemas de elevação Aqua Creek Products F-EZPL2. Aqua Creek Products F-EZPL2 12 páginas. Pool lift and hard seat option
Também para Aqua Creek Products F-EZPL2: Manual (11 páginas), Instruções de instalação, montagem e funcionamento (12 páginas)
Imprimir página
PROCEDURE
Check battery level indicator on control box.
Run the lift through a complete test cycle (fully
extend actuator) to verify it is functioning
properly.
Wash lift with fresh water and dry with clean,
solft, non-abrasive cloth.
Recharge battery.
Visually inspect lift for damage, corrosion, and
loose or missing hardware.
Check all contact points for damage and/or
corrosion.
Repair, clean and apply dielectric grease to all
contact points.
Thoroughly clean lift frame and apply a liberal
coat of car wax to maintain the lift's finish.
Check all Warning and Cautionary labels to
make sure they are not faded or worn. Replace
as needed.
PROPER CARE NOTES:
• Use only fresh water to wash your lift. Do not wash with pool water.
• Use only clean, soft, non-abrasive cloths on your lift.
• Do not store lift in pump room or near chemicals.
• Do not allow children to play on or around this lift.
• When cleaning the lift, do not spray water directly on control box or battery.
• The lift may need to be bonded according to local code requirements.
• If the lift is not used for extended periods, remove the battery from the lift and
store it on the wall charger to maintain the battery's charge. The charger should be
plugged in and in a climate controlled area.
STAIN REMOVAL NOTES:
To remove stubborn stains from finish, spray affected area with mild dish
soap, rub briskly with a 3M Scotch Brite™ pad. Use white epoxy paint to
touch up the finish. Apply wax to protect when dry.
PROPER CARE OF LIFTS
For service and/or replacement parts, contact
DAILY
BEFORE
EACH USE
N/A
N/A
Aqua Creek Products
Toll free: (888) 687-3552
WEEKLY
MONTHLY
N/A
8/15/2022 12:41:43 PM PAGE - 12