Aqua Creek Products Ranger 2 Manual - Página 8

Procurar online ou descarregar pdf Manual para Equipamento de iluminação Aqua Creek Products Ranger 2. Aqua Creek Products Ranger 2 20 páginas. Pool lift
Também para Aqua Creek Products Ranger 2: Manual de instruções (18 páginas), Manual (16 páginas), Manual (12 páginas), Manual (16 páginas)

Imprimir página

Anchor Installation: New Construction

NOTE: For installations where a new deck is being poured, or where a dedicated pad is being poured

just for the pool lift, the concrete must satisfy the ADA requirements outlined on page 3 of this manual.

Your pool deck must be at least 3 feet - 6 inches long by 3 feet - 6 inches wide by 6 inches

thick. It must be reinforced with 4 sticks of #5 rebar each way, 3 inches clear (min) from

the bottom of the footing.

1. Remove 1 nut from each anchor insert. Place the anchor inserts through the larger hole

of the anchor jig plate. Thread the removed nuts back onto the anchor inserts. The anchor

plate should be sandwiched between the two nuts on each anchor insert.

SEE FIGURE A, PAGE 7

2. Install rebar in the open area of the deck.

SEE FIGURE B, PAGE 7

3. Set the anchor system in place. For ADA compliance and clearance, make sure the

center of the large anchor jig plate holes are between 14.5 and 19 inches from the pool's

edge.

SEE FIGURE C

8-AWG SOLID-COPPER WIRE

(ATTACH TO BONDING-GRID)

42"

REBAR

2500PSI MIN

#5 REBAR E-W (4 PCS)

DRILL & EPOXY INTO EXISTING

SLAB (5" MIN EMBED)

*SETBACK DIMENSIONS ARE FOR FLAT DECK APPLICATIONS.

FOR SLOPED DECKS OR OTHER FEATURES, CONTACT AQUA

CREEK BEFORE INSTALLATION.

FIGURE C

*[37 TO 48cm]

14.5" TO 19"

SETBACK

2.5"

MIN

BONDING

-LUG

LABEL

42"

FLUSH W-DECK

4. Make sure the top of each anchor body is

fl ush with the FINISHED deck surface. Each

anchor body can be adjusted individually by

turning the nuts with a large wrench.

5. Bond the anchoring system by using the

bonding lug on the anchor jig plate. Bond

the system according to your local code

requirements.

(See NEC Article 680.26)

SEE FIGURE C

POOL

WALL

6. Pour your concrete and fi nish the pool deck

surface.

SEE FIGURE A, PAGE 7

7. Once the concrete has cured the lift is ready

to be mounted to the anchoring system.

Revised 5/28/21