AVM OVATION A 6.2 Manual de Instruções - Página 10

Procurar online ou descarregar pdf Manual de Instruções para Amplificador AVM OVATION A 6.2. AVM OVATION A 6.2 14 páginas.

3.1.4 Set loudness

If you listen to music at low levels, you often recognize that bass and treble reproduction are

weak. This is because the human ear is not sensitive to bass and treble at low sound levels.

To compensate this you can use the parametric loudness function of the OVATION A 6.2.

This function will increase bass and treble levels when you decrease the volume. When the

volume is increased the frequency response will be more and more flat and remain linear at

high volume levels. In order to obtain best results we recommend you proceed in the

following way: Set the amplifier to a moderate volume level. Using the buttons < VALUE >

(4d, 4e)) choose a loudness curve ("OFF", 1-9) which provides the best sound impression and

exit the menu with button 6 (EXIT).

NOTE: The loudness function selects automatically the correct loudness curve depending on

the actual volume setting. That is why a different curve than the previously selecteded may be

shown in the loudness menu as soon as you alter the volume. This is not a malfunction.

3.1.5 Set balance

Set the balance between right and left channel for optimal stereo image.

3.1.6 Set input attenuation

In case you have connected a signal source with a rather high output level (such as a hifi

component made in the US which are generally known for high outpout levels) you need to

activate the input attenuation option (ATT ACTIVE) of your OVATION A 6.2. This way, an

activated attenuation circuit reduces the incoming audio signal level by 6 dB thus preventing

the input stage from overdrive and distortion.

3.1.7 Set speakers out

Set speakers out seables you to activate or deactivate one or both of the available

loudspeaker outputs (13, 24).

3.2 Personal Setup

The personal setup offers you a range of settings to individualize the device according to your

personal needs. To enter the personal setup menu, please switch off your device on the rear

of the unit at the mains switch (23). Keep the most right key under the display pressed (4c)

while you switch on the unit again (23). As soon as the display shows the personal setup

menu you can release the multifunctional button (4c). When the personal setup is active you

can

select

the

desired

function

using

the

buttons

< ITEM >. The button SELECT activates the function. The setting is done using the buttons

< VALUE >. BACK leads you back to other settings. EXIT exits the personal setup and

stores the settings