AVM OVATION PA8 Manual de Instruções - Página 8

Procurar online ou descarregar pdf Manual de Instruções para Amplificador AVM OVATION PA8. AVM OVATION PA8 18 páginas. Modular preamplifier

2.5 Installation and cooling

The unit doesn't produce much heat. But especially the output cards need cooling.. Therefore it is important,

that the cooling air can flow unhinderedly into the air inlets in the bottom and flow out through the holes in the

rear panels. Direct exposure to sunlight is not recommended, this can heat up the unit.

Connect the unit to the mains outlet by using the power cord which is (in some countries) delivered together

with the unit. Make sure that mains voltage is according to the value printed on the rear panel (near mains

connector (17)).

If the phase indicator LED is on, this indicates the phase is correct. If not, please pull mains plug out of the

wall-socket, rotate it by 180° and plug it in again.

NOTE: Let the unit be switched off until all audio connections are made.

Connect the outputs of your signal sources to the inputs of each card. For more details please refer to the

operating instructions which are delivered together with the individual cards.

Connect the power amplifiers to the preamplifier out cards. For more details please refer to the operating

instructions which are delivered together with the individual cards.

Connect the trigger outputs (12) to the trigger inputs of the power amplifier or (if connected) the subwoofer.

Then these units will automatically switch on and off together with the PA8. The pinning of the trigger outputs

is described in chapter 2.3

If you use an AVM power amplifier of the latest Generation (MA3.2, MA8, SA8) then this unit will

automatically be switched on and off via the connected audio cable. There is no need for an additional

trigger cable (see manual of power amplifier).