AVM OVATION SA 6.2 Manual de Instruções - Página 9

Procurar online ou descarregar pdf Manual de Instruções para Amplificador AVM OVATION SA 6.2. AVM OVATION SA 6.2 12 páginas.

2.6 Set operating mode

permanent: When switched on using the mains switch (13), the unit is permanently ready to

operate until it is switched off with the mains switch.

automatic: The amplifier switches on automatically as soon as a connected pre-amplifier

delivers an audio signal to one of the analog inputs (7, 8). Standby mode is activated as soon

as the pre-amplifier has not delivered a signal for more than 10 minutes.

trigger: Switching to operating mode and to standby is controlled via the trigger input (10).

For details, see section 1.6.

remote: If you happen to use an AVM model of the PA or SD series as a pre-amplifier, your

MA / SA 6.2 can be automatically switched on and off via inaudible digital signals sent over a

connected audio cable – without the need for an additional trigger cable. In addition, the

display brightness can also be remotely controlled – according to the selected setting on the

pre-amplifier (see section 2.4).

To obtain correct values in the power display (see 2.5), it is necessary to select the given

impedance according to your speakers (4 or 8 Ohms). This setting is only for calibrating the

power display and has no influence on the performance of the amplifier itself.

The Reset menu cancels certain or all settings and makes the unit return to default settings.

To enter the Reset menu, please switch off your device on the rear of the unit at the mains

switch (13). Keep the middle key under the display pressed (3) while you switch on the unit

again (13). As soon as the display shows the reset menu you can release the multifunctional

button under the display (3). Now press ALL to reset the unit completely. CANCEL will bring

the unit back to normal operating mode without resetting any item.

After resetting your MA / SA 6.2, the unit needs to be restarted at the mains switch (13).

Switch off the unit, wait for a couple of seconds and turn it on again to complete the reset

procedure.

Use a soft cloth and normal glass cleansing fluid.

CAUTION

Make sure no fluid gets into the unit. Do not use scouring cleaners. They may damage the

surface.