AVM OVATION SA 6.3 Manual de Instruções - Página 10

Procurar online ou descarregar pdf Manual de Instruções para Amplificador AVM OVATION SA 6.3. AVM OVATION SA 6.3 12 páginas.

3. After switching off the pre-amplifier the amp does not automatically switch to STANDBY (after

approx. 5-10 min.) although the "auto" mode is selected

a) Please check whether a low humming or chirping noise is heard from the loudspeakers after

switching off the pre-amplifier. If there is such a noise, scattering emissions within the cable are

interfering with the automatic switch-on circuitry. The unit is interpreting the interference as a music

signal and reacts by not switching off the amp. Avoid interferences by placing the cable. Place

your cable differently. With balanced XLR cables, this fault can also arise from errors in the pin

setting (see section 1.2.3).

4. The amplifier switches off during normal operation

a) This can happen if the temperature inside the unit becomes too high. In this case, the amplifier

switches off and the display shows overheat. Switch off the unit and let it cool down for some

minutes.

3.3

Conditions of warranty (EC only)

If despite expectations a defect occurs that cannot be repaired by yourself or your dealer, we undertake

the repair of your unit free of charge for up to three years from date of purchase. The warranty covers

the costs of material and working time, transport costs are to be borne by the owner.

Provisions for this warranty are:

•

The unit must have been purchased from an authorised dealer. Equipment from other sources

will not be repaired, not even at charge.

•

The warranty registration card, together with a copy of the bill of sale, must be received by us

within four weeks of the date of purchase.

•

The defect must not have been caused by improper handling or misuse.

•

Return the unit to us only in its original packing. If this is not possible we are entitled to refuse

acceptance. We will not assume responsibility for transport damage under any circumstances.

•

A short description of the defect is to be included with the returned unit.

•

In cases of doubt we reserve the right to request a copy of the bill of sale.

•

We also reserve the right to levy a handling charge for items returned without good or valid

reason, or if the unit proves to be not defective.

NOTE: If you are returning the unit from a country other than Germany you should ensure that correct

export documents are obtained. We cannot accept any charges for costs arising from improper or

incomplete export documentation.

If you have purchased your unit from a dealer outside Germany please refer to him or the relevant

importing firm to process the warranty.