Femooi Icee Manual do produto - Página 5
Procurar online ou descarregar pdf Manual do produto para Produtos de higiene pessoal Femooi Icee. Femooi Icee 7 páginas.
Imprimir páginaicee™ Ice-cold Cooling Mode
STEP1: Press the "Cooling button"
cooling mode. Gently massage the cold surface of the
device over the part of the face with enlarged skin-pores to
tighten pores, as well as to enhance the smoothness of your
skin.
After 1.5 minutes, the device will notify you that the cooling
mode is finished by a small vibration.
Tip: The ice-cold cooling function can also be used on the area under
the eyes, to effectively cool down the skin and reduce puffiness
around the eyes.
Pay attention:
* After using the ice-cold cooling mode, please wait for the cooling surface to return to normal tempe-
rature before using it for the next time.
* When the device's temperature is too high, it will automatically enter the protection mode. At this
moment, the ice-cold cooling mode cannot be used anymore, and the device will vibrate twice to
remind.
* After using the ice-cold cooling mode, it is normal that the device feels slightly warm. Immediately stop
using the ice-cold cooling mode if the device is overheating and extremely hot.
About Power and Charging
Charging
icee™ comes included with a dedicated USB magnetic charging cable. You can use any qualified USB
·
adapter to charge icee™ with this cable.
To charge the device, please connect the metal surface of the magnetic head on the end of the USB
·
magnetic charging cable to the device. The cable should be turned to the right-side from the back of
the device. When the magnetic head is close to the device, the magnetic head will automatically snap
into place. Plug the other end of the USB connector into your own USB power adapter and plug the
adapter into the socket.
to start the icee™ice-cold
When icee™ is in normal charging state, the indicator light of the device will blink in a
·
breathing rhythm. When the charging is finished, the indicator light will change from a
breathing rhythm to constantly being on.
icee™ can be charged in both upright position as well as when hanging down (see the
·
figure below).
It will take 5 hours to charge icee™ from an empty battery to fully charged.
·
Pay attention:
* When the magnetic head is close to the charging port on the back of the device and approached
from the right side, the magnetic head will automatically snap into place. When the magnetic
head approaches the charging port from the left side, there will be a repulsive force. In this case,
do not force the head onto the port, since this might damage the device.
* When the battery of icee™ is low, the indicator light will flash for 10 seconds to remind you that
the cleansing mode is still available, however, the ice-cold cooling mode will not work. The dev-
ice will give this reminder until the battery's power is completely exhausted.
Warning:
* Do not immerse the icee™ device into water or other liquids for a long duration.
* Before charging, make sure that the power cable connector is dry and available. Alsoconfirm
that the local power voltage from the outlet matches the indicated required power voltage of
the device.
* Do not charge the device in a location where there is a risk of flooding.